66513949K015 Kenmore Dishwasher Parts List

Inlet fill hose (water fill hose)

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Elbow hose fitting (dishwasher water inlet fitting. Has standard 3/4 inch hose thread on one end and 3/8 inch copper tubing on the other. Copper tubing fitting is compres)

This part has a swivel gooseneck fitting and that allows it to be installed closer to the wall. This part has a 3/4" hose thread on one side and a 3/8" copper tubing on the other side.

Overfill control switch (float switch)

This part is also known as a float switch. This float switch, when activated, stops the flow of water into the dishwasher.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Tub cap (plug, tub)

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Water inlet (water inlet into dishwasher)

This is connected to the water valve, is located on the side of your tub and allows water to enter your dishwasher. ***Note: This part does not include the inlet gasket - must order separately.

Tub sound shield - insulation (tub sound shield)

Thermostat (safety thermostat)

Diverter motor with wire harness (pump diverter motor. Seal for diverter motor shaft only available with the pump sump housing.)

NOTE: This part has been updated by the manufacture and the shaft seal is now incorporated into the sump housing. The seal for diverter motor shaft only available with the pump sump housing.

Hinge-door (door hinge arm, left side)

Screw

This screw is sold individually.

Screw

This part is a replacement screw for your dishwasher. It is made of metal and is approximately ¾ inch long. It is a hex-head screw and is sold individually. It is used to hold the dispenser bracket in place. This part is a genuine OEM part sourced directly from the manufacturer.

Door hinge - right side (door hinge arm, right side)

Air vent gasket (gasket, air vent)

Gasket (flat gasket)

Also known as a washer.