66514043K014 Kenmore Dishwasher Parts List

Door latch - black (door latch *part has been redesigned by the manufacture)

NOTE: This part has been redesigned, it may appear different but will still function the same as the original.

Hose clamp

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Adjuster arm clip (rack adjuster stop clip)

Sold individually.

Inlet fill hose (water fill hose)

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Screw - 8-18 x 5/8 (screw, 8-18 x 5/8)

Sold individually.

Thermal fuse (thermal cut out fuse kit)

This is a replacement thermal fuse for your dishwasher. The thermal fuse is sometimes known as the thermal cutoff. The thermal fuse shuts off the dishwasher if the dishwasher shorts out or overheats. If your dishwasher is cutting out during the cycle, or will not start, you may have an issue with your thermal fuse. If your dishwasher control panel does not light up, the first thing you should check is the fuse. Before you begin to repair this part, be sure to disconnect the dishwasher from the power source, as you will be working around electricity.

Elbow hose fitting (dishwasher water inlet fitting. Has standard 3/4 inch hose thread on one end and 3/8 inch copper tubing on the other. Copper tubing fitting is compres)

This part has a swivel gooseneck fitting and that allows it to be installed closer to the wall. This part has a 3/4" hose thread on one side and a 3/8" copper tubing on the other side.

Turbidity sensor (turbidity sensor mounted in pump sump under dishwasher)

Measures level of soil in the water.

Side mounting bracket kit (dishwasher side mounting kit. This kit is used when mounting the dishwasher to the side of the cabinet.)

This mounting kit can be used on solid surface countertops.

Upper rack wheel (upper dishrack wheel)

Sold individually.

Overfill control switch (float switch)

This part is also known as a float switch. This float switch, when activated, stops the flow of water into the dishwasher.

Tub cap (plug, tub)

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Touch-up paint - black (black appliance touch-up paint.)

16ml

Spring grip retainer (retainer, spring grip)

Hose (hose from circulation pump to sump housing)