66512776K311 Kenmore Dishwasher Parts List

Hose clamp

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Inlet fill hose (water fill hose)

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Screw - 8-18 x 5/8 (screw, 8-18 x 5/8)

Sold individually.

Elbow hose fitting (dishwasher water inlet fitting. Has standard 3/4 inch hose thread on one end and 3/8 inch copper tubing on the other. Copper tubing fitting is compres)

This part has a swivel gooseneck fitting and that allows it to be installed closer to the wall. This part has a 3/4" hose thread on one side and a 3/8" copper tubing on the other side.

Door latch - black (door latch)

Motor (pump diverter motor. Seal for diverter motor shaft only available with the pump sump housing.)

Also know as a diverter valve. This diverter motor is for dishwashers. Diverter motor controls the flow of water to the spray arms. Unplug the dishwasher and shut off the water supply before installing this part. Wear work gloves to protect your hands.

Grommet (circulation pump inlet grommet)

Upper spray arm (sprayarm, third level)

The upper spray arm rotates and sprays water to clean the dishes inside the dishwasher tub. If your dishes are not being cleaned properly, you should check if there is an issue with the spray arm. To check your spray arm, make sure the spray arms can move evenly and freely on their bearing rings and mounting brackets. Remove your spray arm and check to ensure they are straight and undamaged. This spray arm is made of high-quality plastic and is just over 5 inches long.

Turbidity sensor (turbidity sensor mounted in pump sump under dishwasher)

Measures level of soil in the water.

Screen (dishwasher sump filter screen)

Overfill control switch (float switch)

This part is also known as a float switch. This float switch, when activated, stops the flow of water into the dishwasher.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Drain pump (dishwasher drain pump assembly)

Tub cap (plug, tub)

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Hose (hose from circulation pump to sump housing)