66512833K311 Kenmore Dishwasher Parts List

Hose clamp

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Seal (seal at bottom of the dishwasher door)

This part is the replacement door seal for your dishwasher. It is approximately 22 inches long and 2 inches wide. This door seal is made of gray plastic and is found at the bottom the dishwasher. The door seal is designed to seal the gap between the dishwasher tub and outer edge of the door. This helps to prevent leaks when your dishwasher is running. A leaking dishwasher is a good indication that the door seal is damaged. This seal is sold individually and is an OEM part sourced directly from the manufacturer.

Upper dishrack (dishrack)

Rack only.

Water inlet valve

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Seal (cabinet seal between dishwasher and cabinets)

This seal is attached to the inner cabinet to reduce noise.

Drain hose (dishwasher drain hose loop with check valve. Goes from pump to drain hose - 67 inches)

This part is used to drain water from your dishwasher.

Adjuster housing cover (upper dishrack adjuster cover)

The adjuster cover goes on the outside of the adjuster housing. It is used to support the height adjuster and also protects the internal components of the adjuster housing.

Terminal nut

Cover screw (screw)

Sold individually.

Drain hose (drain hose extension. Goes from the drain hose loop to the house drain. 6-1/2 feet.)

This drain hose is 6 and 1/2 feet.

Door spring (dishwasher door spring)

This dishwasher door spring is sold individually. It is recommended if you are replacing one side, to replace both.

Spray paint - 12 oz. - white (spray paint, white, 12 ounces)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Push-in retainer clip (fastener, push-in)

Sold individually.

Hose clamp

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Inlet fill hose (water fill hose)

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.