66513012K111 Kenmore Dishwasher Parts List

Cover screw (screw)

Sold individually.

Drain hose

This drain hose is 6 and 1/2 feet.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

High limit thermostat (thermostat)

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Wheel assembly (wheel)

Sold Individually - 4 required on rack.

Silverware basket

This silverware basket sits in the lower dishrack and holds small utensils like forks, knives, and spoons during the dishwashing cycle. The basket is made of high quality grey plastic and measures approximately 19 inches (length) x 8 inches (height) x 4 inches (deep).

Inlet fill hose (fill hose)

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Spring

This door spring is a genuine OEM replacement part for your dishwasher. The spring ensures that your dishwasher door does not fall open too quickly. If this occurs, one or both springs should be replaced. This part consists of one spring. To replace the spring, you will need to pull the dishwasher about six inches to a foot out from the cabinet. Replacing the spring has been rated as an easy repair by our customers.

Kickplate - black (toe panel)

New Black Single Metal Access Panel Replacement Kit. Replaces old two part toe kick plates. Reuse insulation off old panel or see Recommended Parts.

Grommet

Side mounting bracket kit (mounting bracket)

This mounting kit can be used on solid surface countertops.

Dishrack roller assembly (wheel)

Upper rack wheel and mount assembly (tub wheel)

This mount assembly attaches on either side of the inner cabinet wall for the upper rack. It glides over and under the the slide track.

Access panel (black) (panel)

This part conceals and protects components located beneath the dishwasher tub.

Overfill control switch (switch)

This part is also known as a float switch. This float switch, when activated, stops the flow of water into the dishwasher.