66513014K111 Kenmore Dishwasher Parts List

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Door actuator (actuator)

This part is the door actuator for your dishwasher. It is made of black plastic and is approximately 3 inches long and 3 inches wide at its widest point. The door actuator is found in the control panel, and it releases the door latch when you lift the handle. If your current door actuator is cracked or broken, you may not be able to open your dishwasher door, or the door will not close properly. The dishwasher also may not be able to start, and if this is the case, you will need to replace it. This part is sold individually and is an authentic OEM part.

Touch-up paint - black (tuchup)

16ml

Hose (hose assy)

Water inlet (water inlet valve)

This is connected to the water valve, is located on the side of your tub and allows water to enter your dishwasher. ***Note: This part does not include the inlet gasket - must order separately.

Tub sound shield - insulation (shield)

Upper dishrack track (track)

This track attaches to the inside of the tub for the upper rack to glide in and out.

Dishwasher screw (screw)

Sold individually.

Screw

Dishwasher rinse-aid dispenser cap (cap)

Screw

This part is a replacement screw for your dishwasher. It is made of metal and is approximately ¾ inch long. It is a hex-head screw and is sold individually. It is used to hold the dispenser bracket in place. This part is a genuine OEM part sourced directly from the manufacturer.

Shield

Lower dishrack (dishrack)

This dishrack is for dishwashers. The dishrack holds the dishes in place during the dishwashing cycle. Follow the instructions in the manual when installing this part.

Hinge bushing (bushing)

Dispenser