66513484K902 Kenmore Dishwasher Parts List

Screw - 8-18 x 1/2 (screw)

Sold Individually.

Upper dishrack (dish rack)

Rack only.

Screw

Sold individually.

Water inlet valve (inlet valve)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Drain hose

This part is used to drain water from your dishwasher.

Spray arm seal (seal)

This seal is located between the spray arm and the water feed tube.

Terminal nut

Drain hose

This drain hose is 6 and 1/2 feet.

High limit thermostat (thermostat)

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Push-in retainer clip (retainer)

Sold individually.

Wheel assembly (wheel)

Sold Individually - 4 required on rack.

Sump and motor assembly (pump motor)

This part moves water up from the sump collection area and up through the spray arms.

Door switch (switch)

This dishwasher door switch will shut your dishwasher off when the door is opened.

Silverware basket

This silverware basket sits in the lower dishrack and holds small utensils like forks, knives, and spoons during the dishwashing cycle. The basket is made of high quality grey plastic and measures approximately 19 inches (length) x 8 inches (height) x 4 inches (deep).

Impeller (seal)

This is the replacement impeller kit for your dishwasher. This impeller kit comes with 4 pieces, including the impeller and seals which you will need for the repair. The impeller and seal kit is mounted on the dishwasher motor. If your dishwasher is not cleaning dishes properly, it may be an indication that your impeller has gone bad, and you are not getting proper water pressure. If the seals have gone bad, your dishwasher may start to leak. If you are having either of these problems, you may need to replace the impeller kit. Be sure to disconnect the water and power source from the dishwasher before you begin this repair. This is an OEM part sourced directly from the manufacturer.