6651581590 Kenmore Dishwasher Parts List

Dishwasher door gasket - gray (gasket)

If your dishwasher is leaking during use you may need to replace the gasket. The door gasket wraps around the sides and top of the dishwasher door and provides a waterproof seal between the tub and the door. It is gray in color and made of rubber. Once you have installed the door gasket it is recommend to close the dishwasher door and leave it closed for a few hours to make sure the door gasket properly seals. This is a genuine OEM part.

Lower dishrack (dishrack, lower (includes item 4))

This dishrack is for dishwashers. Dishrack holds the dishes in place during the dishwashing cycle.

Rubber washer (washer, rubber (2))

The black heating element washer goes between the heating element and the dishwasher tub to form a seal where the element attaches to prevent water from leaking during its cycle. If the washer goes bad it will cause water to leak out on to the floor. This part is made of rubber, measures approximately 1” in diameter and is sold individually. This is a genuine OEM part.

Drain and wash impeller kit (impeller, wash (includes items 12 & 13))

This dishwasher drain and wash impeller kit comes with both the drain and wash impeller, gaskets, chopper and installation screw. This part helps stop your dishwasher from leaking and helps with the proper draining of the dishwasher.

Spring, lid

The lid spring helps open the detergent dispenser cover, which is located on the inside of the door panel, when it reaches the cycle to dispense soap into the dishwasher. If the lid will not open or the detergent is not dispensing, you may need to replace the lid spring. This is a genuine OEM part.

Screw (screw (8))

Sold individually.

Hose clamp (clamp, hose)

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Rinse aid cap (wet-agent dispenser cap)

This cap does not require the use of a o-ring seal.

Screw - 8-18 x 1/2 (screw, 8-18 x 1/2 (4))

Sold Individually.

Detergent dispenser cover kit (pin (lid hinge))

This kit also includes the lid hinge pin, spring, snap and latch.

Door panel insert (almond/black)

This panel is reversible, black on one side, white on the other side.

Soap cup latch kit (snap, detergent dispenser)

The latch kit includes the latch and the snap. This part is used to keep the soap dispenser cover closed until activated. It is located on the inside of the door panel on the right side. If your dishwasher is not dispensing detergent, or the latch is broken or damaged, you may need to replace the latch kit. This is a genuine OEM part.

High limit thermostat (thermostat, hi-limit)

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Dishrack (dishrack, upper)

Access panel (panel, access)

This part is located on the bottom.