79031053000 Kenmore Range Parts List

Igniter/orifice mounting screw (screw)

This part is the igniter/orifice mounting screw for your cooktop or range. It is approximately ½ an inch in length and is made of metal. The mounting screw connects the orifice to the cooktop. If the orifice is loose, or the screw is missing, this is the part that will replace it. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.

Cap

This black 9.5K burner cap attaches on top of the burner base and acts like a cover for the burner head and helps to spread the flame for even heat. The burner cap will also protect your burner head from spills. This part measures about 2 1/2” in diameter and is a genuine OEM part.

Cap

The burner cap helps the flame to spread for even heat. The cap sits on top of the burner base and acts like a cover for the burner head. It can also protect your burner head from spills. This part is black in color and just over 2 inches in diameter. If your old burner cap is damaged or missing, this is the part that will replace it. This is a genuine OEM part and is sold individually.

Lp conversion kit (conversion k)

The LP conversion kit is used in ranges

Probe (sensor)

The temperature sensor, also known as an oven probe, helps measure the temperature within the oven cavity. If your oven is too hot, not heating evenly, has little to no heat when baking, or flashing F3/F4 error messages on your control board, you may need to replace this part. This part measures 6" long and is made of metal. Please make sure to disconnect the power to your oven range before starting this repair. This temperature sensor is a genuine OEM part.

Flat glow bar igniter (ignitor)

Left front orifice - 9.5k (orifice)

This burner orifice is a 9.5K natural orifice. The orifice helps regulate the gas flow coming from the burner valve. The size of the orifice opening determines the max power output of the burner. If the opening of the orifice has been damaged or you are converting the range, you will need to replace the orifice. Please remember to disconnect the power and gas supply before starting your repair. This part is made of metal, is a genuine OEM part and sold individually.

Rack

Screw

This is an authentic mounting screw, which works with ranges, wall ovens, cooktops and warming drawers.

Cap (burner cap cover)

Cap

Sold individually.

Broiler pan grate insert (insert broil)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean-up easier. This is a genuine OEM part.

Spark ignitor (module)

The function of the ignitor in your range is to create the spark that ignites the gas on the burners. If your spark ignition system is not functioning properly, you may need to replace the ignitor. This part is approximately 3 inches in length. The ignitor is located in the rear of the range, so you will need to remove the back panel in order to access it for this repair. Before beginning this repair, be sure that the gas valve for the range is shut off. You should also disconnect the power source to the range before you begin.

Door spacer (spacer)

Meat probe sensor (probe)