79036723604 Kenmore Range Parts List

Igniter/orifice mounting screw (screw)

This part is the igniter/orifice mounting screw for your cooktop or range. It is approximately ½ an inch in length and is made of metal. The mounting screw connects the orifice to the cooktop. If the orifice is loose, or the screw is missing, this is the part that will replace it. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.

Temperature sensor (probe)

The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace the temperature sensor. Please make sure to disconnect the power to your range before starting your repair.

Door hinge (hinge)

This hinge is located on each side of the oven door.

Glass (oven glass)

This tempered glass is supplied by the original manufacturer and measures 20 inches by 13 inches. It is an inner door glass, designed for use in ranges/ovens and has several purposes which include providing heat insulation, acting as protective barrier, and providing an opening to monitor the cooking/heating process. Over time the glass can break or break from impact, thermal shock, or improper installation. If the glass is defective, it needs to be replaced promptly to avoid leaking, loss of insulation and potential harm to the user. Remove any fasteners or clips that secure the glass and carefully dispose of it. Position the new glass in the same position and secure it appropriately.

Screw,control mtg. (screw)

Flat glow bar igniter (ignitor)

Rack

Spark module (module)

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

Broiler pan grate insert (insert broil)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean-up easier. This is a genuine OEM part.

Inner glass (door glass)

Outer drawer glide (glide)

As per the factory, the original part was 19 3/4 inches and the new substituted part is 16 1/4 inches. According to the factory, this part will still work with your appliance.

Door spacer (spacer)

Natural gas top burner orifice - 5,000 btu (5k ng orif/b)

Door seal (seal)

This part has been replaced by the manufacture. It may differ in appearance but will still function the same.

Cord

Used with gas ranges.