79060002400 Kenmore Range Parts List

Oven rack

The metal chrome oven rack is a genuine OEM part. The oven rack is located inside of the oven cavity to provide a stable surface for cooking or broiling. This rack measures approximately 23” long x 16” wide and is sold individually. If your rack is rusted, damaged or missing you will need to replace the oven rack. No tools are required for this repair.

Burner grate (grate)

Sold individually.

Steel washer (washer)

This washer works in conjunction with the oven door handle to secure the oven door together. The washer measures 3/4-inch x 1/4-inch, is made of metal and is sold individually. This is a genuine OEM part.

Leveling leg (level leg)

Front burner (burner)

White touch up paint (paint-white)

This is an 18 ml bottle of white appliance touch-up paint. It can be used for refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part. Please remember to wear gloves to protect your hands when using this paint.

Anti-tip kit (anti tip kit)

The anti-tip bracket kit comes with one metal bracket and two installation screws, and is sourced directly from the genuine manufacturer. It prevents the freestanding oven, range, or stove from tipping when force or weight is applied to an open oven door. The bracket is secured to the floor and wall and fits over the rear leveling leg in the back of the appliance, in a cutout specifically designed for the anti-tip bracket. This part is very essential to the safe operation of the appliance. Failure to install the bracket properly can result in the oven tipping or falling and causing injuries.

Oven door seal with clips (oven door seal)

Also known as gasket.

Main top (main)

Screw (screw-8-18x1)

Sold Individually.

Broiler pan grate insert (insert broil)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean-up easier. This is a genuine OEM part.

Handle mounting screw (screw)

Sold individually.

Back burner (burner)

Burner knob (top burner valve knob)

This knob will accept a D-shaped shaft and is sold individually.

End cap (hndle endcap)