79551079011 Kenmore Refrigerator Parts List

Handle screw (handle stopper)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Refrigerator water filter (refrigerator water filter cls30320001)

This OEM filter measures 2.5 inches deep, 12.5 inches high, 5 inches wide and roughly 1.5 lbs. It is recommended to replace this filter every six months or 300 gallons, whichever comes first. If you notice an unpleasant taste in your water or it suddenly dispenses much slower, these are also common indications that a replacement is necessary. It filters sediment, dirt, rust, cysts, lead, mercury, and more. For proper use, operating pressure should be 30-120 PS, operating temperature should be 33-100 degrees Fahrenheit, with a flow rate of 0.5 gallons per minute. Installation is quick and easy and does not require the use of tools.

Guide rail - right side (guide rail)

This is an authentic OEM part sourced directly from the manufacturer. The crisper slide rail for your refrigerator allows the crisper drawer to slide in and out, and supports the drawer as it does so. This part is for the right side of your crisper drawer. Please note that the roller for this guide rail is a separate part under part number PS11759956.

Guide rail - white - left side (guide rail)

The right side to this part is no longer available.

Water inlet valve assembly (water valve)

This water inlet valve has three solenoid valves and push in fittings. When energized this part releases water from the supply line into the ice mold.

Push button switch (switch)

This is a genuine replacement switch. It is a push button style switch that is designed for use in your refrigerator. When the door of your appliance is opened the switch is released, and the light comes on. When you close the door the switch is pressed in, and the light turns off. You may need a putty knife to remove your old switch.

Basket,door (door basket)

Basket assembly,door (ref dr baskt)

Hinge assembly,lower (hinge assembly)

Lever spring (spring)

This genuine OEM lever spring exerts tension between the ice maker door plunger and the ice maker itself on your refrigerator. If there is little to no tension holding your ice door seal in place, the spring may be faulty. This spring is approximately 1-inch long. Remember to disconnect the power to your refrigerator before beginning this repair.

Lever,hinge (hinge lever)

Leg assembly,adjust (leg asy)

Defrost sensor assembly (refrigerator sensor)

Motor,dc

Connector,tube (connector tube)