79571022010 Kenmore Freezer Parts List

Handle screw (handle stopper)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Plastic tube - 5/16 inch (tube, pe)

The 5/16” plastic water tubing attaches to the water inlet valve and goes into the refrigerator. The tubing supplies water to the water dispenser and the ice maker. If the tubing becomes damaged or cracked, it can cause water to leak out onto the floor and the water tubing will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

Door stopper (stopper)

Refrigerator water filter (refrigerator water filter cls30320001)

This OEM filter measures 2.5 inches deep, 12.5 inches high, 5 inches wide and roughly 1.5 lbs. It is recommended to replace this filter every six months or 300 gallons, whichever comes first. If you notice an unpleasant taste in your water or it suddenly dispenses much slower, these are also common indications that a replacement is necessary. It filters sediment, dirt, rust, cysts, lead, mercury, and more. For proper use, operating pressure should be 30-120 PS, operating temperature should be 33-100 degrees Fahrenheit, with a flow rate of 0.5 gallons per minute. Installation is quick and easy and does not require the use of tools.

Deli drawer (tray)

This deli drawer is for refrigerators. Deli drawer holds meats, vegetables and snacks in the fresh food compartment of the refrigerator. Follow the instructions in the owner's manual when installing this part.

Door shelf bin (door basket)

Sold individually.

Water inlet valve assembly (drawing assy)

This includes the primary and secondary valves along with the wire harness.

Primary water valve - single coil (water valve)

Gasket assembly,door (gasket assembly)

Refrigerator ice bin (bucket assembly)

This ice bin is for refrigerators. Ice bin stores ice cubes in the freezer section of the refrigerator. Follow the instructions in the owner's manual when installing this part.

Plastic tube (tube, pe)

This part is the replacement water line or tube for your refrigerator. It is made of white plastic and is sold individually. This tube supplies water to the ice maker and water dispenser If your refrigerator is leaking, or it will not dispense water or ice, you may have a damaged water line. When you replace the water line, you may want to pick up a new water tube union as well. You can use a utility knife to cut the old water line where it is damaged and use the union to attach the new water line to the old one. This tubing is an OEM part from the manufacturer.

Refrigerator light board assembly (led assembly)

This light board is located behind the light lens and has LED lights that illuminate the interior of the refrigerator compartment when the door is opened.

Left side connector rail (connctr,rail)

Cam,shaft (cam)

Cam,shaft (cam)

The door latch cam, also known as a hinge lever, latches the door when you close it. The latch cam attaches to the left side flipper seal cover to catch the pivot guide in the refrigerator to keep the doors closed. This part is approximately 2 1/2” long, white in color, made of plastic and is for the left side. This is a genuine OEM part and is sold individually.