79571039010 Kenmore Freezer Parts List

Handle screw (handle stopper)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Plastic tube - 5/16 inch (tube)

The 5/16” plastic water tubing attaches to the water inlet valve and goes into the refrigerator. The tubing supplies water to the water dispenser and the ice maker. If the tubing becomes damaged or cracked, it can cause water to leak out onto the floor and the water tubing will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

Water inlet valve assembly (valve asy,wa)

This includes the primary and secondary valves along with the wire harness.

Door holder

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Push button switch (push switch)

This is a genuine replacement switch. It is a push button style switch that is designed for use in your refrigerator. When the door of your appliance is opened the switch is released, and the light comes on. When you close the door the switch is pressed in, and the light turns off. You may need a putty knife to remove your old switch.

Roller assembly

Evaporator fan motor (motor)

This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is suggested to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.

Spring,lever (spring lever)

Refrigerator water reservoir (tank asy,wat)

The water reservoir holds the water for the water dispenser as the water chills.

Elbow (connector)

Ice maker assembly kit (icemaker)

Crisper shelf glass (shelf glass)

Cap assembly,head (water filter bypass)

Refrigerator door bin (door basket)

This door bin is for refrigerators. Door bin attaches to the inside of the refrigerator door and mostly holds jars and bottles.

Temperature sensor (controller)

This part monitors the temperature and makes sure the compressor cycles on and off.