79571042010 Kenmore Freezer Parts List

Handle screw (handle stopper)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Glass shelf (shelf glass)

This is the replacement shelf glass for your refrigerator. It is made of glass and is approximately 31 inches wide and 16 inches long. The shelf glass for your refrigerator slides over the crisper cover and acts as a sort of lid. It also creates a shelf that you can place food and beverages on. If your current shelf insert glass is broken, this part is the appropriate replacement. Many of our customers have described this repair as easy. To complete the repair, carefully remove the old glass from the frame and replace it with the new pane of glass. This part is sold individually and is an authentic OEM part.

Door holder

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Roller assembly

Refrigerator flipper assembly (plate asy,fr)

The main top guide pin guides the main top onto the body of the range and helps hold the top in position.

Evaporator fan motor (motor)

This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is suggested to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.

Refrigerator door bin assembly (basket assembly)

Gasket,door (gasket assembly)

Freezer door gasket is on the inner door panel and creates a seal around the door to prevent warm air from entering the freezer compartment.

Light bulb (incandescent lamp)

Gasket assembly,door (gasket asy,d)

Door bin cover (window basket)

Ice maker assembly,kit (icemaker)

Valve,water (water valve)

Tube,plastic (tube)

Temperature sensor (controller)

This part monitors the temperature and makes sure the compressor cycles on and off.