79572029110 Kenmore Freezer Parts List

Handle screw (handle stopper)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Plastic tube - 5/16 inch (tube)

The 5/16” plastic water tubing attaches to the water inlet valve and goes into the refrigerator. The tubing supplies water to the water dispenser and the ice maker. If the tubing becomes damaged or cracked, it can cause water to leak out onto the floor and the water tubing will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

Drawer roller (roller assembly)

Door stopper (stopper)

Screw,customized (screw)

Water inlet valve assembly (harness assembly)

This includes the primary and secondary valves along with the wire harness.

Tray assembly,vegetable (tray assy, v)

This is the replacement vegetable tray for your refrigerator. It is made of white and clear plastic and is approximately 22 inches long, 19 inches wide, and 12 inches deep. The vegetable tray slides into the refrigerator shelf and is used to store vegetables and other food items. The main reason to replace the vegetable tray is if yours is cracked, damaged, or missing. To replace the vegetable tray, simply slide the old pan out, and slide the new one into place. This is an OEM part sourced directly from the manufacturer and is sold individually.

Primary water valve - single coil (water valve)

Refrigerator ice bin (bucket assembly)

This ice bin is for refrigerators. Ice bin stores ice cubes in the freezer section of the refrigerator. Follow the instructions in the owner's manual when installing this part.

Shelf frame assembly - white (cover assembly)

Note: Frame no longer includes rollers and screws. May be ordered separately.

Push button switch (push switch)

This is a genuine replacement switch. It is a push button style switch that is designed for use in your refrigerator. When the door of your appliance is opened the switch is released, and the light comes on. When you close the door the switch is pressed in, and the light turns off. You may need a putty knife to remove your old switch.

Roller assembly

Cam,shaft (cam)

Cam,shaft (cam)

The door latch cam, also known as a hinge lever, latches the door when you close it. The latch cam attaches to the left side flipper seal cover to catch the pivot guide in the refrigerator to keep the doors closed. This part is approximately 2 1/2” long, white in color, made of plastic and is for the left side. This is a genuine OEM part and is sold individually.

Evaporator fan motor (motor,dc)

This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is suggested to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.