79578349802 Kenmore Freezer Parts List

Handle screw (handle stopper)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Refrigerator door switch (pushbutton light switch)

The light switch lights up the interior cabinet of the refrigerator or freezer when the door is opened. If you open the door and the light won’t come on, or the light is always on, you may need to replace the light switch. The switch is white in color and measures approximately 2 1/2”. This is a genuine OEM part. Please remember to disconnect the power before starting the repair.

Drawer rail guide - right side (guide assembly)

The guide rail, also known as a drawer slide rail, is a genuine OEM replacement part for the freezer section of your refrigerator. The rail attaches to the right side of the inside wall of your refrigerator to support the sliding crisper drawer. This slide rail supports the storage basket in your freezer, allowing you to slide it open with ease. If the rail is broken or the drawer is not sliding properly, you will need to replace the slide rail.

Door stopper (stopper)

Refrigerator water filter (refrigerator water filter cls30320001)

This OEM filter measures 2.5 inches deep, 12.5 inches high, 5 inches wide and roughly 1.5 lbs. It is recommended to replace this filter every six months or 300 gallons, whichever comes first. If you notice an unpleasant taste in your water or it suddenly dispenses much slower, these are also common indications that a replacement is necessary. It filters sediment, dirt, rust, cysts, lead, mercury, and more. For proper use, operating pressure should be 30-120 PS, operating temperature should be 33-100 degrees Fahrenheit, with a flow rate of 0.5 gallons per minute. Installation is quick and easy and does not require the use of tools.

Screw,customized (screw)

Lower holder cover (clip)

"Clips"

Bush (bushing)

The hinge bushing is used in conjunction with the opening and closing of the refrigerator/freezer door. The hinge bushing attaches to the inside of the door panel and provides the door hinge pin a smooth surface to pivot on. This part is white in color, made of plastic and measures 1”. This part is a genuine OEM part and is sold individually.

Rail guide assembly - left side (guide assembly)

Lamp cover

This lamp cover is also commonly referred to as a light lens. This is a genuine replacement part. It is used in a refrigerator to cover the light bulb. It is made of clear plastic. It measures 14 inches by 5 1/2 inches. This does not include the white plastic housing that the light is in, this is just the cover. To install your replacement part you simply snap it into place, no tools are required.

Push button switch (switch)

This is a genuine replacement switch. It is a push button style switch that is designed for use in your refrigerator. When the door of your appliance is opened the switch is released, and the light comes on. When you close the door the switch is pressed in, and the light turns off. You may need a putty knife to remove your old switch.

Ice maker assembly,kit (icemaker)

Cam,shaft (cam shaft)

Cam,shaft (cam shaft)

Rail,slide (slide rail)