79578733800 Kenmore Freezer Parts List

Handle screw (handle stopper)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Plastic tube - 5/16 inch (tube, pe)

The 5/16” plastic water tubing attaches to the water inlet valve and goes into the refrigerator. The tubing supplies water to the water dispenser and the ice maker. If the tubing becomes damaged or cracked, it can cause water to leak out onto the floor and the water tubing will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

Door stopper (stopper)

Refrigerator water filter (refrigerator water filter cls30320001)

This OEM filter measures 2.5 inches deep, 12.5 inches high, 5 inches wide and roughly 1.5 lbs. It is recommended to replace this filter every six months or 300 gallons, whichever comes first. If you notice an unpleasant taste in your water or it suddenly dispenses much slower, these are also common indications that a replacement is necessary. It filters sediment, dirt, rust, cysts, lead, mercury, and more. For proper use, operating pressure should be 30-120 PS, operating temperature should be 33-100 degrees Fahrenheit, with a flow rate of 0.5 gallons per minute. Installation is quick and easy and does not require the use of tools.

Deli drawer (tray,f room)

This deli drawer is for refrigerators. Deli drawer holds meats, vegetables and snacks in the fresh food compartment of the refrigerator. Follow the instructions in the owner's manual when installing this part.

Door shelf bin (dairy bank)

Sold individually.

Ice maker assembly (ice maker)

The wire harness is NOT available separately. Refrigerator ice maker kit AEQ36756901 is an original equipment manufacturer (OEM) part that fits some refrigerators in these series: Kenmore 795; Kenmore Elite 795; and LG LFX, LMX and LSC. Ice maker AEQ36756901 receives water from the water inlet, holds the water in the ice mold until the water freezes solid and then automatically ejects the ice and refills to continue the process until the ice storage in is full. This ice maker kit contains the complete ice maker, housing and control device.

Water inlet valve assembly (drawing assy)

This includes the primary and secondary valves along with the wire harness.

Primary water valve - single coil (water valve)

Door gasket - left side (gasket assembly)

This door gasket assembly is for the left refrigerator door. The gasket attaches on the inner door panel to create a seal around the door to keep the cool air inside and avoid the warm air from entering. If your gasket is torn or no longer sealing the door it will need to be replaced. This gasket is gray in color, made of rubber and measures 18” x 40”. To smooth the creases and folds in the new gasket, soak it in warm water and let it dry. You can also try carefully warming it with a hair dryer or heat on a low setting, but be careful not to melt the gasket. This is a genuine OEM part.

Door gasket - right side (gasket assembly)

Refrigerator ice bin (ice bucket)

This ice bin is for refrigerators. Ice bin stores ice cubes in the freezer section of the refrigerator. Follow the instructions in the owner's manual when installing this part.

Refrigerator light board assembly (led assembly)

This light board is located behind the light lens and has LED lights that illuminate the interior of the refrigerator compartment when the door is opened.

Cam,shaft (cam)

Cam,shaft (cam)

The door latch cam, also known as a hinge lever, latches the door when you close it. The latch cam attaches to the left side flipper seal cover to catch the pivot guide in the refrigerator to keep the doors closed. This part is approximately 2 1/2” long, white in color, made of plastic and is for the left side. This is a genuine OEM part and is sold individually.