79640021900 Kenmore Washer Parts List

Hinge assembly

The door hinge attaches the door to the front panel of the washer cabinet. If the door hinge is damaged, or faulty, the door may not close or open properly and can lead to the unit leaking during the wash cycle. This genuine OEM part is sourced directly from the manufacturer, made of stainless steel, and measures approximately 12 inches long x 6 inches wide.

Clamp

The hose clamp works in conjunction with the water hose in the appliance by holding the water hose in place to keep the hose from leaking water on to the floor. If you notice your appliance leaking, you may have a crack in the hose or that the clamp is loose and will need to be replaced. The hose clamp is made of metal, measures approximately 1/2” in diameter and sold individually. This is a genuine OEM part.

Pump casing (casing)

This part connects to the drain pump and motor.

Clamp assembly (clamp)

Bolt assembly (bolt)

Door boot seal - with drain port (gasket)

Also known as a bellow.

Washer motor rotor position sensor (sensor assembly)

The sensor monitors the direction and speed of the spinning rotor.

Hose,connector (hose)

This part is the replacement connector hose or clean-out drain hose for your washer. It is black in color and is sold individually. The connector hose drains water out of the washer if the drain cycle is not working. If the hose breaks, it will not be able to drain the water properly, and you may experience a water leak. Be sure to disconnect your washer from the power source, as well as the water source before you begin this repair. This is an OEM part sourced directly from the manufacturer.

Hose (bellows)

Dispenser assembly (dispenser)

Noise filter assembly (filter)

Holder

Softener cap

This part is the replacement fabric softener cap for your washer. It is also known as the washer dispenser drawer insert. It is made of blue plastic and is approximately 4-1/4 inches by 2-1/4 inches. The fabric softener fits inside the dispenser drawer and holds fabric softener and bleach. The main reason to replace this cap is if it is damaged or missing. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Hose,inlet (hose)

Bracket,hinge (bracket)