9114532190 Kenmore Range Parts List

Bake element (oven bake element. The terminals are male quarter inch spade connectors. The wires push onto the heating elements connectors.)

This partially open-style bake element comes with ¼-inch push-on terminals and is located on the bottom of the oven. This bake element provides heat for baking. If your oven is too hot, not heating evenly, the element is not heating, or has little to no heat when baking, you may need to replace your bake element. You can use a multi meter to test the bake element for electrical continuity to see if you need to replace it. This is a genuine OEM part. Please remember to disconnect the power to the range before starting your repair.

Drip bowl - 8 inch (chrome drip bowl (pan) for 8-inch burner on electric range. This drip bowl sits underneath the heating element to catch drips or spills.)

The chrome drip bowl is located under the burner element to catch anything that may spill over to make cleaning up spills quick. This drip bowl is eight inches in size and is intended for use with rolled terminal style plug-in surface element units. This is a genuine OEM part and is sold individually.

Single heating element support clip (support bracket for oven broil element.)

The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.

Drip bowl - 6 inch (chrome drip bowl for 6" burner, electric range)

This is the drip bowl for your range or cooktop. The drip bowl sits beneath the burner of an electric range and collects any spills during cooking. The bowl is 6 inches in diameter and represents the smaller burner for your range. This product is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Surface burner terminal block kit (surface burner element terminal block with mounting bracket and wires)

The surface burner terminal block kit comes with a terminal block, wire nuts, heat shrink protective tubing, and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

Rolled terminal surface unit - 6" - 1250w (6 inch diameter surface heating element with looped terminal ends)

Screw

Sold Individually.

Large surface burner switch - 2350w 240v (infinite control switch for large surface burner.)

This switch controls the stove top surface burner.

Screw (screw-10-32)

Sold Individually.

Broiler pan - large (broiler pan grill kit, porcelain, includes grill and bottom pan)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below making clean up easier. This part is gray in color, made of enameled porcelain for an easy-to-clean, durable and made to last. The pan measures approximately 17” wide by 13” deep, insert measures 15 1/2” wide by 13” deep. This is a genuine OEM part.

Broil element - 3400w 240v (oven broiler heating element)

Light lens (lens-light)

Light bulb socket (oven light bulb socket assembly)

Range surface element control switch (surface element control switch, small element)

The surface element control switch turns the surface element on and off and controls how much heat the element produces. (1500W)

Surface burner control knob (knob, burner control)

Sold individually. This part accepts a double-flat shaft.