91140469792 Kenmore Wall Oven Parts List

Single heating element support clip (broiler element support)

The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.

Bake element

This bake element is found on the bottom of the oven.

Oven sensor (sensor)

The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace it. Make sure to disconnect the power to your range before starting your repair.

Broil element - 240v (broil element)

The broil element with push-on terminals is located on the roof of the oven cavity to supply heat for broiling. If the element is no longer heating or has shorted out, you will need to replace your broil element. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Screw (screw 10-16 x 7/16")

Sold Individually.

Screw (screw 10-32 x 17/32")

Sold Individually.

Ignitor mounting screw (screw 10-32 x 1/4")

Sold Individually.

Broiler pan - large (broiler pan)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below making clean up easier. This part is gray in color, made of enameled porcelain for an easy-to-clean, durable and made to last. The pan measures approximately 17” wide by 13” deep, insert measures 15 1/2” wide by 13” deep. This is a genuine OEM part.

Oven rack

Sold individually.

Electronic clock oven control (clock/oven control)

The wiring of this part may differ from the original and may need to be installed by an appliance repair person.

Screw (screw 8-18 x 7/16")

Door lock and switch assembly (motor)

Bail (light lens bail)

Washer - 12 pack (washer)

This 12 pack of washers works in conjunction with your oven range. The washers are made of metal and measure approximately 0.5” in diameter. This is a genuine OEM part.

Screw (trim screw - black)

This screw is sold individually. Size 8-18 x 3/4