KitchenAid Dryer Hardware

Roller Support Tri-Ring

Part Number: WPW10512946

The tri ring is used to hold the drum support rollers or the idler pulley onto the shaft. If your dryer will not tumble or is noisy, you may need to replace the tri ring. This is a genuine OEM part and is sold individually.

Igniter Kit

7 Reviews

Part Number: 279311

This silicon carbide igniter with ceramic holder kit includes the 3-inch flat igniter, mounting bracket, 4-inch wire leads, and the plug. It can replace both round and flat igniters. This kit is used for many gas clothes dryers. This part ignites the gas within the dryer to heat the dryer during the cycle, so if your dryer takes too long to dry, has no heat or not enough heat, you may need to replace the igniter. Be sure to disconnect the power source from your dryer before you do this repair. The igniter is very fragile and should be handled with care.

Single Front Panel Cip

1 Review

Part Number: W10854425

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Thrust Washer

Part Number: WP233520

This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.

Screw - 10-16 x 1

Part Number: WP3387230

This screw is sold individually.

Cover Screw

Part Number: WP308685

Sold individually.

Screw, 8/18 x 3/8

Part Number: WP90767

This screw is sold individually.

Screw

Part Number: WP488729

Metallic screw that is less than an inch long. Does not include the plastic washer.

Single Access Panel Spring Retainer/Clip

Part Number: WP3388229

Sold Individually.

Support Roller Clip

Part Number: WP90296

Sold Individually.