Connector Assembly

Part Number: 4933DD3001B

The door hinge cable works in conjunction with the dishwasher door by connecting the door hinge to the door spring and helping to support and balance the weight of the door as you open and close it. If your dishwasher door isn’t closing properly you will need to replace this part. This part measures approximately 12” and is black and white in color. This is a genuine OEM part.

Roller Assembly

Part Number: 4581DD3003B

The lower rack roller and axle attaches to the rack and allows you to slide the lower dish rack in and out smoothly. If a roller becomes damaged or broken it will need to be replaced. This part measures approximately 2 1/2” in diameter, gray in color, made from plastic, and is sold individually. This is a genuine OEM part.

Roller with Axle

Part Number: 4581DD3002A

The rack roller with axle attaches to the upper rack to allow you to move the dishrack in and out with ease along the support rails. The rollers and axles sometimes wear out at the same rate and the manufacturer recommends replacing the axles in pairs. This part is gray in color, made of plastic, and measures 1 1/2” wide. This is a genuine OEM part and is sold individually.

Diverter Motor - 120V 60Hz

(1)

Part Number: 4681ED3001D

The diverter motor works in conjunction with the spray arms in your dishwasher by controlling the flow of water to the spray arms. The motor turns the check valve inside the pump to avert the flow of water between the drain pump and the spray arms. If the motor fails it will cause the dishwasher not to wash or drain and will need to be replaced. This diverter motor is 120 volts and 60 Hz. Please remember to disconnect the power and water supply to the dishwasher before starting the repair. This is an authorized OEM part.

Spring,Hinge

Part Number: 4970ED4004G

The door spring is used to help support and balance the weight of the dishwasher door as it open and closes. The door hinge measures a little over 10” long and made of metal. If the dishwasher door feels heavy, or is noisy when opening or closing , you may need to replace this part. This is a genuine OEM part and is sold individually.

Door Gasket - Black

Part Number: 3920DD3005A

Circulation Pump Motor - 120V 60Hz

Part Number: 4681EA2002H

The circulation pump is used in both washers and dishwashers. In the washer, the pump is used to circulate the water during operation. In the dishwasher, the pump is used to drain the water from the dishwasher. If the circulation pump stops working, it will prevent the washer and dishwasher from working properly and will need to be replaced. This circulation pump is 120 volts, 60Hz and 30 watt and a genuine OEM part. Please remember to disconnect the power and water supply before starting your repair.

Pump Gasket

Part Number: MFZ32863101

The pump gasket is used to prevent water from leaking between the filter and pump housing. The pump gasket helps seal the impeller allowing to maintain the water pressure in the spray arms. If the gasket breaks it will cause water to leak and your dishes won’t be properly cleaned which will result in dirty dishes. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

HOSE ASSEMBLY, DRAIN

Part Number: AEM69493807

This replacement dishwasher drain hose connects the drain pump to the air gap or the garbage disposal to drain the water from the dishwasher. The hose is gray in color and made of plastic. If the drain hose becomes cracked or damaged it will cause a water leak and will need to be replaced. This is a replacement drain hose from the manufacturer. The manufacturer advises that if the drain hose that is being replaced does not have the vent tube going to the water inlet assembly, a new water inlet will need to be purchased. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Accessory Assembly

Part Number: 5001DD4001A

Can be used for both top or side mount applications.