LG Washer Seals and Gaskets

Door Gasket

5 Reviews

Part Number: 4986ER0004F

Also known as a door boot seal or bellow and comes with a drain hole. Door boot 4986ER0004F is an original equipment manufacturer (OEM) part that fits some front-load washers in these series: Kenmore and Kenmore Elite 796; and LG WM and CW. Door boot 4986ER0004F forms a seal between the wash tub and the door, preventing leaks. This door boot includes a drain port; if your 27-inch LG front-load washer was made before September 2007, use door boot 4986ER0004B instead, because those washers don't have a drain port.

Rear Tub Gasket

Part Number: 4036ER2004A

The rear tub gasket is located between the drive shaft and the rear outer tub to form a watertight seal to prevent water from leaking. It is recommended to replace the two bearings at the same time as replacing the tub gasket. The gasket is black in color and measures approximately 3” in diameter. This is a genuine OEM part. Please make sure you disconnect the power and water supply to the washer before starting your repair.

Door Boot Seal

Part Number: MDS47123602

This door boot is for washers. Door boot forms a seal between the wash tub and the door, preventing leaks. Unplug the washer before installing this part. Wear work gloves to protect your hands.

Gasket

1 Review

Part Number: 4036ER4001B

The outer tub gasket is used to create a seal between the front and rear outer tub to prevent water leaking. The tub gasket is located between the front outer tub and the rear outer tub. If your washer starts leaking from between the outer and rear tub, the tub gasket could be worn out or damaged and will need to be replaced. This part is black in color and made of rubber. This is a genuine OEM part. Please remember to disconnect the power and water supply to the washer before starting the repair.

Door Boot Seal

Part Number: MDS47123608

Felt Seal

Part Number: 4036EL3001A

Bellow - Gray

Part Number: MDS47123605

Gasket

Part Number: MDS62058301

This part is the replacement rear tub gasket for your washer. It is made of black plastic and is approximately 3-1/4 inches in diameter. The rear tub gasket forms a watertight seal between the rear tub and the drive shaft. If the gasket is worn or damaged, it may not be able to create this seal, and you may experience a water leak from your washer. Be sure to disconnect the washer from the water and power sources before you begin this repair. This is an OEM part sourced directly from the manufacturer and it is sold individually.

Bellow - Gray With Drain Port

2 Reviews

Part Number: 4986ER0004G

This part is also called the Door Boot Seal. It's the main seal between the front bulkhead and the outer tub.

Washer Door Boot

Part Number: MDS47123619

The door boot forms a seal between the washtub and the door, preventing leaks.