Magic Chef Dryer Wheels and Rollers

Maintenance Kit

11 Reviews

Part Number: 4392065

Includes Belt 8066065, Rollers WPW10314173, Pulley 691366, Clip 90296, Tri-ring W10512946. 4 Roller Kit 4392067

Rear Drum Support Roller Kit

22 Reviews

Part Number: 349241T

This drum support roller kit is used for square-ported model clothes dryers. It has a metallic bearing in its center. This support roller is used to hold the drum in place in the cabinet while letting the drum rotate on the support rollers. If your dryer is noisy, will not tumble, or takes too long to dry you might need to replace the roller. The kit is a genuine OEM kit and it includes two drum support rollers, four tri rings, and one retaining washer. It is recommended that you replace both rollers at once. Please remember to disconnect the power to your appliance before starting your repair.

Drum Support Roller

1 Review

Part Number: WP37001042

This single drum support roller is used for square-ported model clothes dryers. It has a metallic bearing in its center. This support roller is used to hold the drum in place in the cabinet while letting the drum rotate on the support rollers. If your dryer is noisy, will not tumble, or takes too long to dry, you might need to replace the roller. It is recommended that you replace both rollers at once. It is sold individually.

Drum Roller Shaft - Left Side

Part Number: WPW10359270

Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.

Drum Support Roller Shaft - Right Side

Part Number: WPW10359269

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Blower Wheel

1 Review

Part Number: 56000

Part may differ in appearance, but functions same as original part.

Drum Support Roller and Shaft Assembly

Part Number: WP40113601

This drum support roller bracket and shaft assembly is a little over two inches long. It is made of metal.

Front Glide Kit

Part Number: 12002126

This kit includes 2 glides (left and right), 2 pads with adhesive backing and 1 support brace.

Blower Wheel - B/10 Models

Part Number: 31001043

This blower wheel is suitable for some clothes dryers of the 10 and earlier series. Manufactured to fit a 1/2 inch motor shaft, this blower wheel is 3-1/8 inches deep. The diameter of the wheel is 7-1/8 inches, and the spring clamp is not included.

Idler Pulley Shaft

Part Number: WP56461

This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.