Diagram for mat13mn

Search By Keyword

Matching Models

You can view or search all the parts in each section by clicking on the diagram to the left of each part.

Were you looking for...

Search By Keyword

1-15 of 27
DIAGRAM
PART PHOTO
DESCRIPTION
PRICE
AVAILABILITY

Mounting stem/tub seal kit (sub 22204012)

(2)
Part Number: EAP2351899

This tub seal helps prevent any leaking around the tub and the shaft of your washer. If your washer is leaking you may need to replace the seal. The tub seal is located on the bottom of the outer tub, in the center where the transmission comes through to connect to the agitator. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

$58.74

Hose clamp (sub 25-7796)

Part Number: EAP11743008

This washing machine hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

$6.66

Tub bearing kit (bearing, tub)

(1)
Part Number: EAP2347235

The tub bearing kit is used on 2-belt washers. This part helps keep the interior tub spinning correctly. If your washer is leaking, noisy, or shakes and moves, you may need to replace the tub bearing. It is recommended to change the seal kit at the same time you are replacing the tub bearing. This is a genuine OEM part. Remember to disconnect the power and shut off the water supply to the washer before starting your repair.

$43.45

Outer tub to pump hose

(2)
Part Number: EAP11738880

This hose connects the outer tub to the pump of your washing machine. It is twelve inches long and all black in color. This hose is made entirely of rubber.

$23.37

Hose clamp (clamp, 1-1/16)

Part Number: EAP11740613

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

$5.87

Tub bolt (bolt & gasket assy.(short))

Part Number: EAP1964665

This is an outer tub bolt and gasket.

$6.66

Nut- clamp (inner tub clamping nut)

Part Number: EAP11743020

This inner tub clamping nut is just under three inches in diameter, and is made of metal. It has a reverse thread and screws onto the mounting stem.

$35.61

Center seal retaining washer (washer,retaining(cent)

Part Number: EAP11757440

This center seal retaining washer is a little over an inch in diameter. It is made of metal.

$4.68
1-15 of 27