Detailed View

346995-1-S-Whirlpool-341241            -Multi Rib Belt - 92-1/4"

Multi Rib Belt - 92-1/4"

EAP Number: EAP346995
Manufacturer: Whirlpool
Part Number: 341241

This Whirlpool dryer drum belt has four ridges, three grooves. This belt is black in color, and made from rubber. It is approximately 93 inches in length and ¼ inches wide

EAP #:

EAP346995

Your Price

$8.75
Works with the following brands: Kenmore, Whirlpool, KitchenAid, Roper, Magic Chef, Maytag, Crosley, Admiral, Norge, Estate, Inglis, Amana, Jenn-Air, Hoover.
Works with the following products: Dryer.

This part works with the following models:

EasyAppliance Number: EAP346995
Manufacturer Part Number: 341241
Brand Model Number Description
Kenmore10686294140Dryer
Kenmore10686294340Dryer
Kenmore10686294540Dryer
Kenmore10686294740Dryer
Kenmore10686294840Dryer
Kenmore11060012000Dryer
Kenmore11060012001Dryer
Kenmore11060012002Dryer
Kenmore11060022010Dryer
Kenmore11060172000Dryer
Kenmore11060172001Dryer
Kenmore11060172002Dryer
Kenmore11060202990Dryer
Kenmore11060212990Dryer
Kenmore11060232000Dryer
Kenmore11060232001Dryer
Kenmore11060232002Dryer
Kenmore11060522900Dryer
Kenmore11060602990Dryer
Kenmore11060612990Dryer
Kenmore1106062110Dryer
Kenmore11060622990Dryer
Kenmore11060702990Dryer
Kenmore11060712990Dryer
Kenmore11060722990Dryer
Kenmore11060724990Dryer
Kenmore11060727990Dryer
Kenmore11060802990Dryer
Kenmore11060812990Dryer
Kenmore11060814990Dryer




Expert Repair Guide

  1. Now remove the screws from the front panel and lift the front panel forward and up, you can now remove it and set it out of the way.
  2. Then roll the belt off of the idler so we can lift the drum out of place.
  3. While supporting the drum with one hand, reach in on the right hand side to remove the belt.
  4. Pay attention to how that belt comes off the drum, around the motor pulley, back in underneath the idler pulley and on to the drum.
  5. Take note of how that belt is orientated on those two pulleys, because you’ll need to know that for reassembly.
  6. Simply roll the belt off the motor pulley and slide the old belt off of the drum.
  7. To install the new belt drape it around the drum, keeping in mind you need to keep the ribbed side of the belt against the drum.
  8. To reassemble make sure that our belt is roughly in position on the motor pulley, then put your idler in the slot and support the drum in an upright position.
  9. Now roll the belt over the top of the idler, in through the opening.
  10. Put some tension on the idler and roll the belt on to the motor pulley.
  11. Ensure everything is lined up by rotate the drum at least a full revolution.
  12. With everything aligned, you’re now ready to reattach the front panel.
  13. Then reconnect the wire harness to your door switch and make sure that your felt is laying flat on the rear bulkhead.
  14. The final step is to replace the top of the dryer and reinstall the lint filter.