Detailed View

6447706-1-S-GE-WE1M1067-Drum Bearing Slide - Green

Drum Bearing Slide - Green

EAP Number: EAP6447706
Manufacturer: GE
Part Number: WE1M1067

This GE drum bearing slide is sold individually. They attach to the outer-most sides of the dryers drum bearing. Manufacture recommends replacing both slides at the same time. These drum bearing slides are approximately 3 inches long.

EAP #:

EAP6447706

Your Price

$4.28
Works with the following brands: General Electric, Hotpoint, Kenmore.
Works with the following products: Dryer, Washer Dryer Combo.

This part works with the following models:

EasyAppliance Number: EAP6447706
Manufacturer Part Number: WE1M1067
Brand Model Number Description
Kenmore363DDE8509RCMAADryer
Kenmore363DDE8509RCMWWDryer
Kenmore363DDE9600RCMAADryer
General ElectricBWXR473ET0WWDryer - Electric
General ElectricBWXR473ET2WWDryer - Electric
General ElectricBWXR473ET3WWDryer - Electric
General ElectricBWXR473ET5AADryer - Electric
General ElectricBWXR473ET5WWDryer - Electric
General ElectricBWXR473GT0WWDryer - Gas
General ElectricBWXR473GT2WWDryer - Gas
General ElectricBWXR473GT3WWDryer - Gas
General ElectricBWXR473GT5AADryer - Gas
General ElectricBWXR473GT5WWDryer - Gas
General ElectricDBB3300EA0AADryer - Electric
General ElectricDBB3300EA0WWDryer - Electric
General ElectricDBB3300EA1AADryer - Electric
General ElectricDBB3300EA1WWDryer - Electric
General ElectricDBB3300GA0AADryer - Gas
General ElectricDBB3300GA0WWDryer - Gas
General ElectricDBB3300GA1AADryer - Gas
General ElectricDBB3300GA1WWDryer - Gas
General ElectricDBB5000EF0GGDryer - Electric
General ElectricDBB5000GF0GGDryer - Gas
General ElectricDBB5000GF1GGDryer - Gas
General ElectricDBLR333EE0CCDryer - Electric
General ElectricDBLR333EE0WWDryer - Electric
General ElectricDBLR333EE1CCDryer - Electric
General ElectricDBLR333EE1WWDryer - Electric
General ElectricDBLR333EE2CCDryer - Electric
General ElectricDBLR333EE2WWDryer - Electric




Expert Repair Guide

  1. To replace the drum bearing slide, first make sure to disconnect power from the dryer
  2. Remove the screws holding the back cover from the control panel
  3. Then remove the top panel, to access the screws on top of the control panel
  4. Once those are removed, lift off the control panel and set it on top of the dryer.
  5. Then disconnect the two wiring harnesses from the door
  6. Next, remove the screws on the front panel so you can pull it forward and off the front of the dryer
  7. You may need to support the drum to loosen the front panel
  8. Once it’s been removed, you’ll have access to the drum bearing slides; these are located around the edge of the drum and can be removed by gently prying them off with a screwdriver.
  9. Once you’ve remove the old slides, just push the new slides in place
  10. Installation is simply the reverse of removal.