Range Brackets and Flanges

Element Support and Clip

5 Reviews

Part Number: W10909479

The element support and retaining clip helps secure the heating element in place inside the microwave. The retainer clip and support are included. NOTE: The manufacturer has modified the original design of this part to increase durability. As a result, this part may take additional effort to install. The design includes a metal clip, which helps hold the top of the ceramic bracket in place. To install this part, you will need to remove the microwave from the unit. Then open the cabinet to access the area above the supports to insert the clip.

Single Heating Element Support Clip

3 Reviews

Part Number: WB2X9719

The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.

Dual surface element switch

1 Review

Part Number: 316238201

This switch controls the stove top surface burner. This surface element control switch is for ranges. Surface element control switch turns the surface element on and off and controls how much heat the element produces. Unplug the range or shut off the house circuit breaker for the range before installing this part.

BRACKET ANTI-TIP Assembly

Part Number: WB02K10254

Bearing Retainer

Part Number: WE1M300

There is a slot in it for a ground strap.

Anti-Tip Kit

Part Number: 316112005

The anti-tip bracket kit comes with one metal bracket and two installation screws, and is sourced directly from the genuine manufacturer. It prevents the freestanding oven, range, or stove from tipping when force or weight is applied to an open oven door. The bracket is secured to the floor and wall and fits over the rear leveling leg in the back of the appliance, in a cutout specifically designed for the anti-tip bracket. This part is very essential to the safe operation of the appliance. Failure to install the bracket properly can result in the oven tipping or falling and causing injuries.

Receptacle Clip

Part Number: WB17T10009

Clip only.

TOOL

Part Number: 318246702

STACK KIT FOR LONG VENT DRYER

1 Review

Part Number: W10869845

Anti-Tip Bracket

Part Number: WB2K20

Includes screw.