Roper Dishwasher Hardware

Heating Element Brass Nut

2 Reviews

Part Number: 154106202

The heating element nut is used to install and secure the heating element in your dishwasher. If your dishwasher is leaking you may need to replace the nut. The manufacturer suggests replacing replace both nuts at the same time. This heating element nut is a genuine OEM part and is sold individually.

Rubber Washer

Part Number: WP717273

The black heating element washer goes between the heating element and the dishwasher tub to form a seal where the element attaches to prevent water from leaking during its cycle. If the washer goes bad it will cause water to leak out on to the floor. This part is made of rubber, measures approximately 1” in diameter and is sold individually. This is a genuine OEM part.

Torx Screw

Part Number: WP3368921

7-18 x 3/4" - sold individually.

Cover Screw

Part Number: WP308685

Sold individually.

Hose Clamp

Part Number: WP596669

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Screw, 8/18 x 3/8

Part Number: WP90767

This screw is sold individually.

Screw - 8-18 x 1/2

3 Reviews

Part Number: WP302868

Sold Individually.

Push-In Retainer Clip

Part Number: WP3400918

Sold individually.

Screw

Part Number: WP488729

Metallic screw that is less than an inch long. Does not include the plastic washer.

Screw

1 Review

Part Number: WPW10348409

Sold individually.