Roper Range Elements and Burners

Oven Bake Element

10 Reviews

Part Number: WPW10308477

This Whirlpool OEM 2400-watt bake element has push-on terminals and is located on the bottom of the oven cavity. The bake element supplies heat while baking. If the oven is not heating properly the bake element may have burned out. If the element has burned out there would be visible damage such as holes, cracks, or blisters. When replacing the element, do not allow the wires to fall back through the rear of the oven. Disconnect the power to the range before starting your repair.

Bake Element - 2600W 240V

14 Reviews

Part Number: WP308180

The 2600 watt 240 volts bake element is located inside the oven on the bottom to supply heat while baking. This closed hinged style bake element is 15 3/4-inch long 16 5/8-inch wide, terminal depth is 3-inch and they are 1 3/4 inches apart. If your oven is not heating evenly, the element will not heat, or there is little to no heat when baking, you may need to replace the element. This is a genuine OEM bake element. Please remember to disconnect the power to your oven before you start your repair.

Bake Element - 240V 2100W

9 Reviews

Part Number: 326791

This bake element is a partially open tapered style with push on wire terminals.

Surface Burner - 8 Inch - 2600W

Part Number: WP660533

This 8” plug in style surface burner element provides heat to the cooking surface of your range. The burner element has looped terminal ends, 2600 watts, and a 5-turn. If the burner element is not heating it could be the element or the burner switch. You can use a multimeter to test the element or the switch for continuity. This is a genuine OEM part; the manufacturer recommends replacing the burner receptacle when you replace the surface burner element. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. This part is sold individually.

Heating Element Connection Wire Kit

1 Review

Part Number: 279457

This kit is used for electric clothes dryers, and it comes with a yellow wire nut.

Standard Y-Frame Range Surface Burner

3 Reviews

Part Number: WP660532

This standard Y-frame 6” surface element is a genuine OEM part that supplies heat to the cooking surface on your range. It has four turns, a black center medallion, looped terminal ends and carries 15000 tts. If your element is not heating, you may need to replace it. Please be sure to disconnect the power to your range before starting your repair. The manufacturer suggests replacing the receptacle at the same time.

Heating Element

6 Reviews

Part Number: WP4391960

The drum glide helps the front drum rotate smoothly and quietly while operating. If your dryer won’t tumble or is noisy, the glide could be worn down, causing a metal on metal noise. In this case it will need to be replaced. It is recommended to replace both glides at the same time and two is required for the dryer. The drum glide is a genuine OEM part and is sold individually. Please remember to disconnect the power to the dryer before starting your repair.

Receptacle Kit

1 Review

Part Number: 814399

This surface burner receptacle assembly comes with the receptacle, two wires, two wire nuts, and two pieces of heat-shrink tubing.

Single Heating Element Support Clip

3 Reviews

Part Number: WB2X9719

The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.

Broil Element

3 Reviews

Part Number: W10856603

This broil element is found on the roof of the oven.