Samsung Dryer Parts

Heating Element - 5300W

1 Review

Part Number: DC47-00019A

Includes the insulators and restring already attached. This dryer heating element produces heat to dry clothes in a dryer and is located in the rear end. If the heater element is burned, dryer does not heat or over heats, or clothes take too long to dry, then replacing this part could solve your problem. The tools needed for this repair project are: Phillips screwdriver, putty knife, needle nose pliers. To repair, first remove the main top of dryer and remove ground strap at the rear. Next, disconnect two wire harnesses that hold front panel to the cabinet to pull out front panel. Once you have access to the inside of the dryer, refer to the manual for further installation instruction. As a safety precaution, remember to unplug appliance from power source before beginning this repair project.

Drum Support Roller & Axle

2 Reviews

Part Number: DC97-16782A

Sold individually.

Idler Pulley Assembly

7 Reviews

Part Number: DC93-00634A

Drive Belt

4 Reviews

Part Number: 6602-001655

Light Bulb - 10W

Part Number: WP22002263

This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.

Heater Duct Assembly w/ Thermostats

9 Reviews

Part Number: DC97-14486A

This genuine OEM heater duct assembly in your dryer directs hot air into the drum during operation. Generally, it can be found behind the drum or at the rear of the dryer. If this assembly becomes damaged, you may encounter problems such as clothes not drying properly or drying unevenly. This kit includes the housing with the heating element coil and attached insulators.

Filter Case

1 Review

Part Number: DC61-02610A

Thermal Fuse

1 Review

Part Number: DC47-00015A

This thermal cut-off fuse (part number DC47-00015A) is for dryers. Thermal cut-off fuse DC47-00015A shuts off the heat if the dryer overheats. Unplug the dryer before installing this part. Wear work gloves to protect your hands.

Lint Filter Case

Part Number: DC61-02595A

This lint filter case, also known as a lint filter screen case, helps to trap lint and debris from laundry and prevent it from clogging your dryer vent. It is specially designed for Samsung dryers. The lint filter case includes mesh fabric in a plastic casing. It has a length of 12 inches, and a width of 8.75 inches. If the lint filter case is visibly damaged, it will need to be replaced to keep your dryer running efficiently. Other signs of a faulty lint filter case include your clothes not drying as quickly as usual, an unpleasant odor in the dryer, and an increased amount of lint on your clothes.

Dryer Radiant Flame Sensor

Part Number: WP338906

This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.