2 Parts List

Sealed burner cap with electrode (sub 12500051)

This burner cap assembly is sold with the spark electrode. Please note this part has been redesigned and no longer requires a gasket. Sold individually.

Defrost timer (refrigerator defrost timer kit. This timer is designed for continuous or cumulative run defrost systems. Turn the dial on the timer clockwise to advan)

This 120 volt, 60Hz defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, freezer section too warm or freezer not defrosting you might need to replace the defrost timer. This is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.

Door cam - black (lower door cam)

The refrigerator uses a set of cams to help with the closing of the doors and help to keep them in position. These cams are mounted around the door pivot point and are made up of a series of ridges and valleys to help keep the door in position. If your refrigerator uses a door closer, the door should shut all by itself. This part is black in color, made of plastic, and is sold individually. This is a genuine OEM part. Note: As per the manufacturer a new screw is needed to mount the door cam. This door cam is sold individually.

Freezer door gasket (door gasket)

Air filter

The air filter helps the refrigerator eliminate odors by removing odor-causing particles. It is recommended to replace your air filter every 6 months to ensure maximum performance. This air filter measures approximately 7-inch wide by 5-inch deep, is black in color and is a genuine OEM part.

Meat drawer rail - left side (mea hanger)

This drawer rail supports the left hand side of the sliding drawer. The mounting screws are sold separately.

Leveler-foot,screw,f/s,nylon (range leveling leg, black plastic.)

This part is used to support and keep your range level. You can adjust the height of the leveling leg to help level your range. The leveling leg is black in color and made of plastic. The manufacture has updated this part from the original. This part now measures approximately 1.859" and sold individually. This part is a genuine OEM part. This leg may be shorter than the original but is the factory replacement. Longer leg is not available.

Screw (refrigerator screw)

Sold individually.

Surface burner receptacle kit (sub 12001676)

The surface burner terminal block kit includes one plastic block, metal bracket, wires, and high-temperature nuts. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This part is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

Trim ring - 6 inch (chrome trim ring for 6-inch burner.)

This 6 inch high rise burner trim ring is intended for use with detached style low rise tilt lock surface mount burners on ranges.

Ice bin auger drum (drum)

This white ice bin auger drum comes with a washer.

Hinge bearing (closer hinge bearing)

Sold individually. Also known as a short door closing cam.

Crisper drawer cover - no glass (cover-crisper pan - lower)

This part contains molded glide rails for the crisper pan. It does not come with the glass shelving. The glass is not included. Must be ordered separately.

Washer lid switch (switch, lid)

The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed. This part includes the grounding wire.

Control bracket (bracket)

This bracket holds the micro switches and the light in the freezer dispenser section.