31-117-00 Parts List

Drip bowl - 8" (chrome drip bowl (also called a drip pan) for 8-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the bu)

The eight-inch drip bowl sits under the surface burner element to collect anything that may drip or spill over, to make cleaning up quick. This bowl measures approximately 10-inch in diameter at its widest point at the top. If your drip bowl becomes damaged or rusted it is best to replace the drip bowl to avoid any grease or spills from dripping down inside the range. This chrome drip bowl is compatible with most electric ranges that utilize plug-in surface burners. This is a genuine OEM part and is sold individually.

Surface element - 8 inch - 220v (stove top coil surface heating element, 8 inch. If the element does not heat either it or the control switch is defective. The coil can be tested to d)

The coil burner element is eight inches in diameter. It has four turns, 220 volts and looped terminal ends. The coil burner element provides heat to the cooking surface on your range. You might need to replace this part if your element is not heating. It might have shorted out around the coil or the terminal block; you can test the coil to see if the burner or the switch may be at fault. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. The element is a genuine OEM part and is sold individually.

Drip bowl - 6" (chrome drip bowl for 6-inch burner. This drip bowl sits underneath the burner to catch drips or spills.)

This six-inch heavy chrome drip bowl is compatible with electric ranges that utilize plug-in surface burners. This bowl has a narrow 3/8-inch lip. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Surface element - 6 inch (range/stove surface element (6-inch). If the surface element won't heat, either the surface element or the surface element switch may be defective.)

The standard Y-frame 6” surface element supplies heat to the cooking surface on your range and is a genuine OEM part. It has a black center medallion and looped terminal end. If your element is not heating, shorted out around the coil or if the terminal block shorted out and burnt out the contacts on the end, you may need to replace the element. Please be sure to disconnect the power to your range before starting your repair. Note: The manufacturer suggests replacing the receptacle at the same time.

2 pack light bulb - 40w

Element (oven broiler heating element)

Element (bake element)

Thermstat (oven thermostat)

4 wire cord - 4ft - 50amp (electric range power cord kit, 4 foot 50 amp 4 wire with closed eyelets and strain relief)

4`-3 wire 40amp ran (electric range power cord kit, 4 foot 40 amp 3 wire w/open eyelets & strain relief)

6'rng50a4s cs6 cord (range power cord. 6 foot 50 amp 4 wire with closed eyelets and strain relief)

Cord (electric range power cord kit, 6 foot 40 amp 3 wire)

Knob-selector (selector knob)

Discontinued (surface burner control knob, sim-2-3-4-5-6-hi, chrome and black)

Use mcn 5606 (range power cord, 6 foot, 3 wire, 50 amp)