31-3649-00 Parts List

Terminal block kit (stove top surface element terminal block kit with interchangeable mounting brackets. The kit also includes ceramic wire nuts, heat shrink protective t)

This surface burner terminal block kit comes with interchangeable mounting brackets, ceramic wire nuts, heat shrink protective tubing and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or is not heating properly, it is likely an issue with the terminal block and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

Surface element - 8 inch - 2600w (8 inch electric coil surface element with looped terminals, 2600 watts. 5 turns.)

This surface burner element is eight inches in diameter. It has five turns, 2600 watts and looped terminal ends. The element provides heat to the cooking surface on your range. If your element is not heating, you may need to replace this part. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. The element is a genuine OEM part. It is sold individually.

Surface element - 8 inch - 220v (stove top coil surface heating element, 8 inch. If the element does not heat either it or the control switch is defective. The coil can be tested to d)

The coil burner element is eight inches in diameter. It has four turns, 220 volts and looped terminal ends. The coil burner element provides heat to the cooking surface on your range. You might need to replace this part if your element is not heating. It might have shorted out around the coil or the terminal block; you can test the coil to see if the burner or the switch may be at fault. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. The element is a genuine OEM part and is sold individually.

6-inch coil burner element (6-inch electric coil surface element with looped terminals, 1250 watt, 4 turn.)

This 6-inch element has looped terminal ends, 1250 watt, four turn and comes with a black medallion center. The element provides heat to the cooking surface on your range. If your element is not heating, you may need to replace the element. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. The element is a genuine OEM part and is sold individually.

Surface element - 6 inch (range/stove surface element (6-inch). If the surface element won't heat, either the surface element or the surface element switch may be defective.)

The standard Y-frame 6” surface element supplies heat to the cooking surface on your range and is a genuine OEM part. It has a black center medallion and looped terminal end. If your element is not heating, shorted out around the coil or if the terminal block shorted out and burnt out the contacts on the end, you may need to replace the element. Please be sure to disconnect the power to your range before starting your repair. Note: The manufacturer suggests replacing the receptacle at the same time.

2 pack light bulb - 40w

Thermstat (oven thermostat)

4 wire cord - 4ft - 50amp (electric range power cord kit, 4 foot 50 amp 4 wire with closed eyelets and strain relief)

4`-3 wire 40amp ran (electric range power cord kit, 4 foot 40 amp 3 wire w/open eyelets & strain relief)

Porcelain drip pan - small (porcelain surface burner drip pan, small burner)

6'rng50a4s cs6 cord (range power cord. 6 foot 50 amp 4 wire with closed eyelets and strain relief)

Cord (electric range power cord kit, 6 foot 40 amp 3 wire)

Use mcn 5606 (range power cord, 6 foot, 3 wire, 50 amp)

Discontinued (surface burner control knob, sim-2-3-4-5-6-hi, chrome and black)

Pan-burner (porcelain drip pan for 8" electric surface burner)