36371542411 GE Washer Dryer Combo Parts List

Drive belt (belt drive)

This dryer drum drive belt is 89.5" long and has four ribs. This part helps spin the drum during the drying cycle.

Push-to-start switch (switch pts)

This switch is used to activate the dryer.

Drum bearing slide (bearing slide)

This OEM replacement dryer slide bearing is white in color, and approximately 3 inches long. The slide bearings are supportive linings for your dryer. If they have eroded, or are damaged, the drums will scrape against metal during the drying cycle which will produce a squealing, or scraping sound.

Interlock switch (switch interlock)

This switch is multi purpose, for a dishwasher the switch is a simple on/off mechanism that prohibits the appliance from operating when the door is open. For a dryer, this switch will let the dryer know if the belt breaks and shut power off to the dryer. If your dryer will not operate or your dishwasher will not start you may need to replace the switch. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Drum glide bearing - white (sold individually) (bearing slide)

Top bearing

Note: The drum slides should also be replaced when your replacing the drum bearing. Slides are NOT included. This part helps your dryer operate as quietly as possible.

Door latch (latch)

This part helps to keep the door closed while the machine is running.

Door switch

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Lid lock & switch assembly (lock lid)

The door latch lid lock is to lock the door on your washer when the appliance is in use. Your washer will not start if your door is not locked. If your latch is broken, you may not be able to start a cycle or open your washer door. It is mostly black in color and made of plastic. This part measures approximately 3.75 by 3.5 inches.

Door handle (handle door)

Hub nut (nut hub)

This hub nut is a genuine OEM replacement part for your stackable washing machine. Removing the hub nut may require a spanner wrench, as per the manufacturer specifications. Replacing this part requires some disassembly of the agitator assembly. The nut should be turned clockwise to remove it.

Igniter (igniter asm)

NOTE: Be very careful to not handle the igniter by its gray part as it's very fragile. Hold it by its white tip only.

Tub seal (seal tub)

The tub seal is manufactured to create a watertight seal between the tub and the inner spin basket. Your seal will wear over time causing the rubber to dry out and crack, breaking the seal in your washer. You may need to replace this part if you notice leaking in your appliance. This part is about 2.75 inches in diameter, is made of rubber, and is black in color.

Door strike (strike door)

TThe door strike for your dryer is mounted on the dryer frame that the door shuts onto. It fits into the door catch on the door and keeps the door closed. If the door strike is damaged or missing, the door will not lock properly and not only will this cause the door to swing open, but it won’t allow the dryer to start properly. It is a small piece of metal, about 1 inch in length and is sold individually.

High limit thermostat - l315-65 (thermostat hi-limit)

This part is the replacement high-limit thermostat or safety thermostat for your dryer. The high-limit thermostat is found on the upper right-hand side of the heater housing, and it cuts off power to the dryer motor if the temperature reaches an unsafe level. If you push the start button and nothing happens, the high-limit thermostat should be tested for continuity and replaced if the contacts are open. Be sure to disconnect power to the dryer before you begin this repair. This part is sold individually and is an OEM part.