38H42TEV Maytag Range Parts List

Surface burner - 8 inch - 2600w (8-inch diameter plug-in surface heating element with looped terminal ends. 5 turn. 2600 watt.)

This 8” plug in style surface burner element provides heat to the cooking surface of your range. The burner element has looped terminal ends, 2600 watts, and a 5-turn. If the burner element is not heating it could be the element or the burner switch. You can use a multimeter to test the element or the switch for continuity. This is a genuine OEM part; the manufacturer recommends replacing the burner receptacle when you replace the surface burner element. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. This part is sold individually.

Standard y-frame range surface burner (6-inch diameter plug-in surface heating element with looped terminal ends. 4 turn. 1500 watt.)

This standard Y-frame 6” surface element is a genuine OEM part that supplies heat to the cooking surface on your range. It has four turns, a black center medallion, looped terminal ends and carries 15000 tts. If your element is not heating, you may need to replace it. Please be sure to disconnect the power to your range before starting your repair. The manufacturer suggests replacing the receptacle at the same time.

Oven door spring

This oven door spring is six inches long, and is made of metal.

Terminal block (terminal block for main power supply or cord. Nuts not included.)

The terminal block provides a way of connecting individual electrical wires and offers protection from electrical surges, voltages and currents. This part will also allow you to attach the power cord to the inner wiring of your range. If the terminal block has shorted out or the range is not getting the proper power, this part will need to be replaced. The nuts are not included with the terminal block, they must be ordered separately. This is a genuine OEM part. Please remember to disconnect the power to the range before starting the repair.

Surface element kit (surface coil element replacement kit, 2 eight inch elements, 2 six inch elements, four receptacles and related hardware.)

This kit includes two 8" elements, two 6" elements, four receptacles and any remaining hardware needed for installation.

Thermostat knob

This knob accepts a D-shaped shaft.

Oven door gasket (oven door gasket/seal)

Lamp switch (switch, oven lamp)

Oven door stop (oven door hinge)

Broil element kit (element kit)

This broil element is a little over seventeen inches long, and is not quite thirteen inches wide. It has screw on terminals and a terminal depth of just over three inches. The terminals are just two inches apart. This broil element comes with two screws and an instructions sheet.

Cord-power (electric range power cord kit, 4 foot 40 amp 3 wire w/closed eyelets & strain relief)

Hinge - right side (door hinge bracket, right side)

The hinges allow the door to swing up and down. The hinges must be properly adjusted in order for the door to close properly.

Discontinued (trim bezel)

Discontinued (oven control board)

Discontinued (oven door latch)