40441 Parts List

Hose assembly,drain

Cap,drain hose (washer drain pump filter drain hose plug)

This drain hose plug, also known as a hose cap, is a genuine OEM part for your washing machine. This plug caps the drain hose from the pump housing, and helps prevent leaks from your washer. Before beginning this repair, make sure the power and water sources to your washer are shut off. To access the pump housing, open the pump filter cover, pull out the drain hose, remove the old plug and replace it, first draining the remaining water from the drain hose.

Bolt assembly

Hinge assembly

The door hinge attaches the door to the front panel of the washer cabinet. If the door hinge is damaged, or faulty, the door may not close or open properly and can lead to the unit leaking during the wash cycle. This genuine OEM part is sourced directly from the manufacturer, made of stainless steel, and measures approximately 12 inches long x 6 inches wide.

Third level spray arm (spray arm asm 3rd level)

Water is forced through this spray arm by the unit's pump and motor assembly. The force of the water propels the spray arms, spraying water and detergent onto the dishes on the dishrack. This spray arm does not come with the screws.

Clamp (washer hose clamp)

The hose clamp works in conjunction with the water hose in the appliance by holding the water hose in place to keep the hose from leaking water on to the floor. If you notice your appliance leaking, you may have a crack in the hose or that the clamp is loose and will need to be replaced. The hose clamp is made of metal, measures approximately 1/2” in diameter and sold individually. This is a genuine OEM part.

Detergent cup release arm (@cam det.Cup)

This is the replacement detergent cup release arm for your dishwasher. It is made of black plastic and is sold individually. The detergent cup release arm is found on the inside of the dishwasher door, and it is the part that releases both the detergent and the rinse-aid. If the rinse-aid and detergent are not being released during the dishwasher cycle, or you notice that the release arm is cracked or damaged, then you will need to replace it. A damaged detergent cup release arm can also lead to a door latch failure on your dishwasher, and it may cause the dishwasher not to start. This is an OEM part sourced directly from the manufacturer.

Bellow - gray with drain port (door boot seal (or door gasket) with drain port. If the washer is leaking, the door boot may be torn. Door boots are commonly torn as a result of over)

This part is also called the Door Boot Seal. It's the main seal between the front bulkhead and the outer tub.

Drain hose (no longer available)

This drain hose is an OEM, manufacturer-approved replacement part for your dishwasher. The drain hose filters out the wastewater from the dishwasher. If there is a hole in it, water will leak out of your dishwasher. Shut off the water and power to the unit before beginning this repair. Accessing the drain hose involves unscrewing the dishwasher and pulling it out. Remove the clamp holding the hose in place to its connection under the sink, using a 5/16ths socket. Disconnect the fill line. Use a 1/4 inch nut driver to loosen the clamp at the other end of the drain hose. Keep a towel handy for any water still inside. Keep the clamps for use on your new drain hose. Reinstall all hoses and lines in reverse order.

Bolt assembly

Detergent cup cover (cover, det cup)

Lifter assembly

Hinge

The locking pin is used to hold the shock absorber on the washer. There is a pin used at the bottom and top of the shock absorber. Sold individually.

Armature link (@armature & link)

Clamp assembly