6440A REV H Norge Washer Parts List

1-15 of 44,162

Drum bearing slide - white (dryer drum slide)

This single white drum bearing slide attaches to the outer-most sides of the bearing to help support the front of the drum as it rotates. If your dryer is making loud noises or the drum will not tumble, you many need to replace the slides. The manufacturer recommends replacing both slides at the same time; there are 2 slides per dryer. This is a genuine OEM part. Please make sure to disconnect power to the dryer before starting your repair.

Easy Part #:

EAP755842

Availability:

In Stock

Price:

$8.30

Drum bearing slide Green (slide drum Green)

This single green drum bearing slide attaches to the outer-most sides of the bearing to help support the front of the drum as it rotates. If your dryer is making loud noises or the drum won?t tumble you many need to replace the slides. The manufacturer recommends replacing both slides at the same time. There are 2 slides per dryer. This is a genuine OEM part. Please make sure to disconnect the power to the dryer before starting your repair.

Easy Part #:

EAP6447706

Availability:

In Stock

Price:

$8.35

Multi rib belt - 92-1/4" (sub 31531589)

This dryer drum belt has four ridges, three grooves, 1/4-inch wide and 92 1/4-inch long. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Easy Part #:

EAP346995

Availability:

On Order

Price:

$14.49

Dryer thermal fuse (one time use thermal fuse)

This thermal fuse is used in dryers as a safety mechanism that stops the flow of electricity to the motor circuit when a dryer overheats. This replacement part features two 3/16 inch terminals, and is sold individually. When this fuse is faulty, your dryer will not start or it will not heat properly. This is a one-time fuse, meaning it cannot be re-set. It must be replaced when there is no longer continuity between the terminals. It attaches to the blower wheel housing. Blown fuses can be caused by clogged dryer vents. We recommend checking to make sure all of the vents are clear when you perform this repair.

Easy Part #:

EAP11741460

Availability:

In Stock

Price:

$14.08

Heating element - 240v 5400w (use wpl 279838)

This 240V/5400W heating element is strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current, causing the wire to heat up. The heat produced is used to dry the clothes in your dryer. If the dryer has no heat, takes too long to dry, or the heating element burns out, the heating element will need to be replaced since it cannot be repaired. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Easy Part #:

EAP334313

Availability:

In Stock

Price:

$57.83

Agitator directional cogs (use wpl 285751)

These agitator directional cogs are commonly referred to as dog ears. They come four in a package and are usually used with direct drive washing machines. When the teeth on the outer edge are worn down the cogs will not engage with the upper agitator, causing it not to agitate properly. It is recommended to replace all four at the same time. These agitator directional cogs are ?-inch high and 1-inchlong and they are a genuine OEM part.

Easy Part #:

EAP388034

Availability:

In Stock

Price:

$2.53

Direct drive motor coupling (coupling, motor and isolation)

The newer version of the coupler kit is made with new metal sleeves for added strength. This part is located between the motor and transmission on the direct drive washer that does not have a belt. The coupler will break to protect the motor from damage if the drive motor system seizes up. If your washer will not fill, will not agitate or spin, but it will drain the water from the tub, you may need to replace this part because it has failed. This is a genuine OEM part. Disconnect the power to your washer before starting the repair.

Easy Part #:

EAP1485646

Availability:

In Stock

Price:

$16.79

Lower rack wheel kit - 8 pack (roller asm lwr rack rear)

The lower rack wheel kit includes 8 wheels and 8 axels for your rack. If your dishrack is not moving in and out of the dishwasher properly you may have a broken or missing wheel and it will need to be replaced. The wheel and axle are white in color and made of plastic. This is a genuine OEM part kit.

Easy Part #:

EAP11726733

Availability:

In Stock

Price:

$27.54

Single lower wheel stud/axle (stud roller)

The rack roller axle attaches the roller to the lower rack to allow you to move the dishrack in and out with ease. The axles sometimes wear out at the same rate and the manufacturer recommends replacing them in pairs. This part is light gray in color, made of plastic and measures 1” x 1” x 1/2” deep. The wheel is not included, just the axle. This is a genuine OEM part and is sold individually.

Easy Part #:

EAP2353872

Availability:

In Stock

Price:

$2.32

Direct drive water pump (white direct drive water pump - two ports)

This pump is intended for use with washing machines that do not have belts. This drain pump has two ports for water to pass through: a large one, and a smaller one. This part is used to remove water from the tub during the drain cycle. If your washer is leaking, not draining, pumps but will not spin or fills and drains at the same time you may need to replace the pump. The pump is located on the motor and is attached by two clips. This part is white in color, made from plastic and is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Easy Part #:

EAP11741239

Availability:

On Order

Price:

$39.48

Front drum bearing (drum bearing)

The drum support bearing helps your dryer operate as quietly as possible by allowing the front of the drum to glide smoothly on the felt seal of the front panel when the drum is rotating. If your dryer is noisy or making a squeaking sound, the slides are probably worn and both slides will need to be replaced. This part measures 10-inches in height and 19 1/2-inches inside width. Four drum glides are used with the drum support bearing and are sold separately. The support bearing is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Easy Part #:

EAP960316

Availability:

In Stock

Price:

$39.94

Rack slide end cap (GE dishwasher upper dishrack slide rail stop clip)

This white rack track stop is used for your upper dishrack track to prevent the rack from sliding off the slide rail. If your rack is falling off the track, you may need to replace the track stop. This is a genuine OEM part and is sold individually.

Easy Part #:

EAP2370502

Availability:

In Stock

Price:

$1.50

Chrome drip bowl - 8 inch (sub 74001213)

This eight-inch chrome drip bowl is intended for use with rolled terminal style plug in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Easy Part #:

EAP11750107

Availability:

In Stock

Price:

$4.68

Replacement ice maker (sub r0156669)

This is a replacement ice maker assembly. The ice maker receives water from the water inlet valve and will freeze until ice cubes are formed. Once the water has been frozen the cubes will be ejected from the mold in to the ice bucket. The ice maker will continue the process until the ice bucket has reached the limit. If your ice maker is not making ice you may need to replace this part. Disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part. NOTE: This part has been updated by the manufacturer and does not include the cover, ice level arm or the wire harness. You can reuse those from the original ice maker.

Easy Part #:

EAP2121513

Availability:

On Order

Price:

$112.33

Drip bowl - 6 inch (sub 74001212)

This six-inch chrome drip bowl is intended for use with rolled terminal-style plug in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Easy Part #:

EAP2366565

Availability:

In Stock

Price:

$10.71

1-15 of 44,162