72039 LG Refrigerator Parts List

Handle screw (door handle mounting post)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Refrigerator door switch

The light switch lights up the interior cabinet of the refrigerator or freezer when the door is opened. If you open the door and the light won’t come on, or the light is always on, you may need to replace the light switch. The switch is white in color and measures approximately 2 1/2”. This is a genuine OEM part. Please remember to disconnect the power before starting the repair.

Refrigerator water filter (water filter)

This refrigerator water filter replacement is for 2010 LG refrigerators that have either forward French doors or are the four-door dispensing models. This filter is designed to minimize impurities that can cause ill-tasting water or an unpleasant smell. It reduces sediment, dirt, rust, limescale, sand, and many other contaminants that can be harmful to your health and the life of your appliance. This filter should be replaced every 6 months or 200 gallons to ensure top quality performance. To remove your unwanted filter, press the push button to open the filter cover (water may spill from the hole), pull out the old cartridge in a downward motion. To install the new filter, make it so the ears are in the horizontal position and push the new cartridge into the housing until it stops. Push the filter upward until it is secure. Click the cover to lock it in place. Run water for approximately 5 minutes to prep the filter for use, and discard water. Reset the “filter reset” button if applicable.

Plastic tube - 5/16 inch

The 5/16” plastic water tubing attaches to the water inlet valve and goes into the refrigerator. The tubing supplies water to the water dispenser and the ice maker. If the tubing becomes damaged or cracked, it can cause water to leak out onto the floor and the water tubing will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

Refrigerator spring (refrigerator door mullion spring.)

This is a replacement door mullion spring for your refrigerator. The door mullion is the flap that allows the doors on your French-door style refrigerator to close. The spring allows the mullion to fit into a latch on the refrigerator door frame, and lets the door stay closed properly. If you have a damaged spring, your door will not close properly. This part is sold individually.

Door stopper

Deli drawer (fresh room tray assembly)

This deli drawer is for refrigerators. Deli drawer holds meats, vegetables and snacks in the fresh food compartment of the refrigerator. Follow the instructions in the owner's manual when installing this part.

Door shelf bin (door basket assembly)

Sold individually.

Water inlet valve assembly (primary and secondary water inlet valve assembly with wire harness)

This includes the primary and secondary valves along with the wire harness.

Primary water valve - single coil

Door gasket - left side

This door gasket assembly is for the left refrigerator door. The gasket attaches on the inner door panel to create a seal around the door to keep the cool air inside and avoid the warm air from entering. If your gasket is torn or no longer sealing the door it will need to be replaced. This gasket is gray in color, made of rubber and measures 18” x 40”. To smooth the creases and folds in the new gasket, soak it in warm water and let it dry. You can also try carefully warming it with a hair dryer or heat on a low setting, but be careful not to melt the gasket. This is a genuine OEM part.

Door gasket - right side

Refrigerator ice bin (bucket assembly,ice)

This ice bin is for refrigerators. Ice bin stores ice cubes in the freezer section of the refrigerator. Follow the instructions in the owner's manual when installing this part.

Door holder

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Push button switch

This is a genuine replacement switch. It is a push button style switch that is designed for use in your refrigerator. When the door of your appliance is opened the switch is released, and the light comes on. When you close the door the switch is pressed in, and the light turns off. You may need a putty knife to remove your old switch.