72372 LG Refrigerator Parts List

Handle screw (door handle mounting post)

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as they commonly wear at the same rate. This is about 1 inch long and metallic in color.

Basket assembly,door

Filter assembly,air cleaner (refrigerator compartment air filter. Should be replaced at least once a year to keep pesky odors at bay.)

Refrigerator Air Filters are a key component for neutralizing odors and ensuring a fresh stream of air into your refrigerator. Swapping your old filter out for a fresh one isn’t difficult and should take less than five minutes. This OEM filter measures approximately 3 inches (length) x 3 inches (height) x 5 inches (Depth). Air filters should be changed every 6 months depending on usage.

Door holder

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Spring,lever

Ice maker assembly - 3 wire (refrigerator icemaker assembly. Be aware the secondary or smaller wire connector has 3 wires in it. If original icemaker has a 6 wire connector see it)

NOTE: The Secondary (smaller) wire connector has 3 wires in it. If original ice maker has 6 wire connector see part number AEQ73110205. Please verify connector before ordering.

Refrigerator water reservoir (water tank)

The water reservoir holds the water for the water dispenser as the water chills.

Gasket,door

Freezer door gasket is on the inner door panel and creates a seal around the door to prevent warm air from entering the freezer compartment.

Gasket assembly,door

Water inlet valve

Switch,micro

Compressor (replacement compressor)

This part must be installed by a licensed and trained LG technician that is able to perform a software update, which is required for the installation of this compressor. Part number CJT30000002 is needed to perform the update. Also, the three pins on the side of the new compressor may be oriented differently than the original. If different, when installing the new compressor the compressor electrical connector must be rotated 45 degrees counter-clockwise.

Cap assembly,head (water filter bypass cap)

Refrigerator ice container assembly

Front door mullion (plate assembly,front)