Hello!
You're visiting the Easy Appliance Parts site in U.S.
Would you like to shop on the Canadian site?
This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.
Easy Part #:
EAP11740482
Availability:
In Stock - Ships Today
Price:
$4.54
The retaining clip goes onto the end of the roller axle and holds the rear wheel onto the axle. If the ring is broken, damaged, making noises, or will not tumble, you will need to replace it. This is a genuine OEM part and is sold individually.
EAP11740487
$8.56
This screw is sold individually.
EAP11746840
$6.52
Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.
EAP11748588
$7.15
This v-shaped spin belt helps transfer power from the motor to the transmission to help pump the water in and out of the washer. It also helps runs the spin cycle in the washer.
EAP11740578
$42.41
This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.
EAP11743008
$6.49
The adjustable leveling leg is used to support and keep your washer level. If your washer shakes and moves during cycles you may need to replace the leveling leg. The stop nut is included with the leveling leg. The rubber foot is not included, it must be ordered separately. Order the quantity you need as they are sold individually. This is a genuine OEM part.
EAP2021026
$18.07
This spring retaining clip is used to hold the front panel onto the top of the washer. If your front panel is loose you might need to replace the clip. The clip is made entirely of metal and is used for some washing machines. This part is not quite an inch long and is sold individually. This is a genuine OEM part.
EAP11739294
$11.06
This wheel has a center metallic bearing. A dryer's idler pulley wheel serves to help the belt to rotate the drum.
EAP11742250
$39.39
This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.
EAP11742857
$53.80
This v-style spin and agitate belt is 28-3/4 inches long and half of an inch wide. It is all black in color and made entirely of rubber.
EAP11740577
$34.16
This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.
EAP11740613
$9.58
This hose attaches to the pump to help remove the water out of the washer. 7 feet in length.
EAP11742254
$37.61
EAP11741443
$5.73
Sold Individually.
EAP11757438