CSF19ERP Hotpoint Refrigerator Parts List

Light switch (refrigerator light switch. This switch activates the refrigerator light when the door is open. It also prevents the dispenser from working if the door)

The refrigerator light switch turns the interior light off and on when you open or close the refrigerator door. The light switch also prevents the front dispenser from working if the refrigerator door is opened. If the switch has shorted out or the light bulb is not turning on when the door is open, you may need to replace the switch. This switch is white in color and measures approximately 1 1/2” L x 1 1/4” W. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting the repair.

Evaporator fan blade kit (fan blade, plastic)

Condenser fan motor (condenser fan motor kit, ¼” spade terminal connection. *note: If original motor has a wire harness connection see related item below.)

This condenser fan motor operates in a clockwise fashion. The fan itself has two 1/4 inch spade terminals. It carries 2 watts and 115 volts. This motor NO longer comes with cover for terminals.

Defrost thermostat (defrost thermostat kit, 60 degrees)

This refrigerator defrost thermostat will cut out at 60 degrees Fahrenheit and kick back in when the temperature drops to 40 degrees Fahrenheit. Use it for your GE brand refrigerator.

Heater and bracket kit (defrost heater kit, side by side)

NOTE: This it is just the heaters and the jumper wires between the two heaters.

Defrost timer (defrost timer assembly. Turn the dial on the timer clockwise to advance it into and out of defrost.)

This refrigerator defrost timer will cycle for twenty-five minutes after every six hours of run time. The timer itself is made of plastic, but its terminals are bent and the leads are external.

Single water valve (water inlet valve for round cube icemaker, with gasket)

This single outlet valve comes with a gasket and is intended for refrigerators that have ice makers which make round ice cubes. The water inlet valve will release water from the supply line into the ice mold and from the water dispenser in the refrigerator. If the ice maker is not making or dispensing ice, not dispensing water, or leaking, you may need to replace the water inlet valve. This water inlet valve is a genuine OEM part. Remember to disconnect the power and water supply to your refrigerator before beginning this repair.

Evaporator fan motor (evaporator (freezer) fan motor assembly)

This evaporator fan motor operates in a counter clockwise fashion. This motor's stack is 3/8 of an inch, and the motor has two terminals: one on the right side, and one on the left side. Use this evaporator fan motor for your GE brand refrigerator.

Ice maker seal kit (ice maker push kit with new shaft, seal and screw. *washer removal and seal install tools no longer available from GE)

This newly redesigned icemaker seal kit is used to rebuild the ice maker cube ejector. The kit comes with a new shaft, seal, and screw. General Electric no longer carries the washer removal and seal install tools. This seal kit is a genuine OEM part.

Cut to fit door gasket kit - gray (refrigerator/freezer door gasket kit, cut to length, gray)

This gray door gasket kit is cut to fit your refrigerator, though some assembly is required. Use it for your GE brand refrigerator.

Cold control thermostat (temperature control thermostat kit)

This cold control thermostat cycles on and off regularly to keep your refrigerator cold.

Comp. Repl. Kit r-12 (replacement compressor kit)

Fan blade (condenser fan blade)

Relay

GE refrigerator/freezer repair manual (GE refrigerator repair manual)

Make repairs on your own using this instructional manual from GE. This manual includes step-by-step photos, diagnostic charts, preventative maintenance, and easy to follow instructions.