CSG7601WW P1143398NWW Caloric Range Parts List

Flat style oven igniter (ignitor)

This part is used to ignite the gas to light the oven burner in your range. If your oven is not heating, check the igniter to make sure it is glowing. If the igniter is glowing and your oven is not heating, your igniter is not strong enough to heat the oven and you will need to replace it. When replacing the igniter, be very careful not to touch the black element part of the igniter as it is very fragile. You will need to reuse the original bracket when installing the new igniter.

Oven igniter (use mac 31940001)

This flat style gas oven igniter has ceramic housing and comes with a connector. The igniter body is just over three inches in length. Be very careful to not touch the black element part of this igniter as it is very fragile.

Spark ignition electrode (electrode, spark igni)

This top burner igniter is used to create a spark that will light the gas and start the burner when the burner knob is depressed and turned. The mounting bracket is included with the igniter. If your element will not heat, will not start or the gas igniter glows but will not light, you may need to replace the igniter. This top burner igniter is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.

2 piece broiler pan (sub 12500100)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean up easier. The measurements for the pan set are 1-1/2-inch x 12-3/4-inch x 16-3/4-inch and is a genuine OEM part.

Wire oven rack

This is a genuine OEM part that is used inside your range/oven to provide a durable surface for your cookware. The rack measures approximately 23 inches wide and 16 inches deep. The part is made of metal and is sold individually.

Double burner bowl

This black double burner bowl is eighteen inches long and nine and a half inches wide.

Anti-tip bracket (use mac 31970801)

Sold individually.

Oven temperature sensor (sensor, temperature)

The temperature sensor detects the temperature within the oven cavity and sends the information to the electronic control board. If your oven is too hot or not getting to the correct temperature, you may need to replace the sensor. This part has a body length of just over three inches and is a genuine OEM part. Please remember to disconnect the power to the oven before starting your repair.

Stand mixer screw (screw, #10-32 x 5/16 pan ph h)

This screw is sold individually.

Surface burner head (top burner (large 12/)

Sold individually.

Hinge kit - right side (sub r0706011)

The oven door hinge assembly attaches to the right side of the door allowing the oven door to open, close, and stay open at an angle. If your oven door is not working properly then you may need to replace the hinge. It is recommended to replace both hinges at the same time. The hinge measures approximately 11 1/2” long, is made of metal, includes a spring and two screws. This is a genuine OEM part.

Frame screw (screw, #10-12 x 500 ab (zn))

Sold Individually.

Spark ignition module with bracket (sub 32020101)

This part comes with the mounting bracket.

Hinge kit - left side (sub r0706010)

The oven door hinge kit attaches to the left side of the door to help control the opening and closing of the oven door. The door hinge also allows the oven door to stay open. The door hinge kit includes the left side hinge, screws and the spring. This hinge measures approximately 11 1/2” long and is made of metal. The manufacturer suggests using the pointed screw to cut threads in the new hinge holes.

Top burner with electrode - medium - 9k (top burner (medium 9k)