DV210AES Samsung Dryer Parts List

Drive belt (dryer drum drive belt. This slender belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley.)

Idler pulley assembly (idler pulley and bracket for dryer drum belt)

Screw (screw 8 x 1/2)

This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.

Heating element - 5300w (dryer heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the c)

Includes the insulators and restring already attached. This dryer heating element produces heat to dry clothes in a dryer and is located in the rear end. If the heater element is burned, dryer does not heat or over heats, or clothes take too long to dry, then replacing this part could solve your problem. The tools needed for this repair project are: Phillips screwdriver, putty knife, needle nose pliers. To repair, first remove the main top of dryer and remove ground strap at the rear. Next, disconnect two wire harnesses that hold front panel to the cabinet to pull out front panel. Once you have access to the inside of the dryer, refer to the manual for further installation instruction. As a safety precaution, remember to unplug appliance from power source before beginning this repair project.

Assembly duct heater;27-drye (dryer heating element assembly. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause.)

Drum support roller & axle (dryer drum roller assembly. Includes the roller shaft and mounting clips. As the bearing in the roller wears, it self-lubricates so no grease is neede)

Sold individually.

Thermistor (dryer thermistor. If the dryer displays a fault code the thermistor may be defective.)

Thermal fuse (dryer thermal fuse on heater housing (non-resettable). The original thermo-protector is riveted to the mounting bracket.)

Thermal fuse (dryer thermal fuse (also called the thermal limit). Located on the blower housing. The thermal fuse blows to cut off power to the dryer if the dryer o)

Dryer leveling leg (leveling leg)

Leveling leg supports the dryer. Adjust the height of the leveling leg to make the dryer level.

Moisture sensor (dryer moisture sensor. The moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dry.)

Assembly bracket thermostat (thermal fuse with bracket, located on the element housing. The fuse is not resettable and will need to be replaced if blown. If the dryer does not hea)

Case-filter(u);big-bang (lint filter screen cover)

High limit thermostat (dryer high-limit thermostat, l260-50f. If the dryer overheats, the high-limit thermostat cuts off power to the dryer. If the dryer won't heat, the hig)

This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 260 degrees Fahrenheit. The element will kick back in when the temperature drops to 210 degrees Fahrenheit - the differential of 50 degrees.

Leveling leg (dryer leveling leg.)

This part is sold individually.