DV316LEWXAA Samsung Dryer Parts List

Light bulb - 10w (light bulb, 10 watt.)

This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.

Drive belt (dryer drum drive belt. This slender belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley.)

Idler pulley assembly (idler pulley kit)

Screw (screw 8 x 1/2)

This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.

Heating element - 5300w (dryer heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the c)

Includes the insulators and restring already attached. This dryer heating element produces heat to dry clothes in a dryer and is located in the rear end. If the heater element is burned, dryer does not heat or over heats, or clothes take too long to dry, then replacing this part could solve your problem. The tools needed for this repair project are: Phillips screwdriver, putty knife, needle nose pliers. To repair, first remove the main top of dryer and remove ground strap at the rear. Next, disconnect two wire harnesses that hold front panel to the cabinet to pull out front panel. Once you have access to the inside of the dryer, refer to the manual for further installation instruction. As a safety precaution, remember to unplug appliance from power source before beginning this repair project.

Assembly duct heater;27-drye (dryer heating element assembly. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause.)

Drum support roller & axle (dryer drum roller assembly. Includes the roller shaft and mounting clips. As the bearing in the roller wears, it self-lubricates so no grease is neede)

Sold individually.

Drum support roller with axle (dryer drum support roller with axle and retainers)

Sold individually.

Thermistor (dryer thermistor. If the dryer displays a fault code the thermistor may be defective.)

Heating element

This element is strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used to dry the clothes in your dryer.

Thermal fuse (dryer thermal fuse on heater housing (non-resettable). The original thermo-protector is riveted to the mounting bracket.)

Thermal fuse (dryer thermal fuse (also called the thermal limit). Located on the blower housing. The thermal fuse blows to cut off power to the dryer if the dryer o)

Thermal fuse with bracket (thermal fuse)

This part is the replacement thermal fuse for your dryer. When you order this part, you will receive the fuse itself, as well as the bracket that mounts it to the dryer. The thermal fuse is approximately 2 inches wide from end to end. It is a safety device inside the dryer that shorts out if the dryer overheats. When the fuse shorts out, the dryer will function properly. You can test your thermal fuse for continuity using a multimeter. Be sure to disconnect your dryer from the power source before you begin this repair. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Thermistor

This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating.

Drive belt (dryer drum drive belt)

This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.