GBS18HBPC GE Refrigerator Parts List

Door shelf retainer bar end cap (freezer door shelf retainer bar endcap)

This is a replacement shelf bar end cap. The end cap connects to the shelf bar on either side, and then snaps into position on the freezer door. This will allow you to store items in the freezer door. It is a little more than 2 inches long and is made of white plastic. To replace the end cap, you can simply depress the locking tab and remove the entire bar and end cap assembly. Then, use a flat blade screwdriver to depress the locking tab, and the endcap will detach. Finally, snap the new end cap locking tabs into place, and snap the bar assembly back onto the freezer door. This product is sold individually.

Package of 12 screws (screws, pkg of 12.)

This is a package of twelve Phillips-head screws. They can be used as replacement screws in refrigerators, ice makers, or freezers. Be sure to check that your appliance model is compatible with these screws. The screws are approximately ¾ of an inch in length.

Shelf support end cap - right side (shelf support cap, right hand)

Door shelf end cap - left side (door shelf end cap, left hand)

Grommet / tube assembly (icemaker fill tube assembly)

This is a replacement fill tube and grommet assembly for your refrigerator. This part acts your water line to your ice maker. If you’re noticing water in the back of the refrigerator or any kind of leak, or if your ice bucket isn’t filling up with as much ice, you may need to change out the fill tube and grommet assembly. When you purchase this part, you get the water line, as well as the fill tube and grommet. This is an OEM part sourced directly from the manufacturer.

Ice cube tray

14 Cube.

Defrost timer (defrost timer. Turn the dial on the timer clockwise to advance it into and out of defrost.)

This refrigerator defrost timer will cycle for thirty minutes after every ten hours of run time.

Blade conf fan assembly (condenser fan blade)

Evaporator fan motor assembly (evaporator fan motor kit)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Overload/start relay combination (compressor start device (relay and overload))

This part helps protect the motor from overheating.

Fan motor grommet (grommet fan motor)

Can be used with the evaporator or condenser fan motor.

Screw

Size: 10-16 ab. * Part may differ in appearance, but functions same as original. Sold Individually.

Icemaker fill cup (icemaker water fill cup)

Compressor kit (refrigerator compressor kit. This part must be installed by a licensed repair technician.)

Defrost thermostat (thermostat, defrost)

This part acts as a safety device against over-heating in case of mechanical failure.