GR-L258SSWQ Parts List

Plastic tube - 5/16 inch (plastic tube, 5/16")

The 5/16” plastic water tubing attaches to the water inlet valve and goes into the refrigerator. The tubing supplies water to the water dispenser and the ice maker. If the tubing becomes damaged or cracked, it can cause water to leak out onto the floor and the water tubing will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.

Ice maker assembly (refrigerator icemaker assembly. If the icemaker is not making ice, make sure the freezer is cold enough to cycle the icemaker (zero degrees fahrenheit)

The wire harness is NOT available separately. Refrigerator ice maker kit AEQ36756901 is an original equipment manufacturer (OEM) part that fits some refrigerators in these series: Kenmore 795; Kenmore Elite 795; and LG LFX, LMX and LSC. Ice maker AEQ36756901 receives water from the water inlet, holds the water in the ice mold until the water freezes solid and then automatically ejects the ice and refills to continue the process until the ice storage in is full. This ice maker kit contains the complete ice maker, housing and control device.

Primary water valve - single coil (refrigerator water inlet valve assembly. If the icemaker or water dispenser does not work then the valve may be restricted and need replacement.)

Door gasket - left side (refrigerator door gasket)

This door gasket assembly is for the left refrigerator door. The gasket attaches on the inner door panel to create a seal around the door to keep the cool air inside and avoid the warm air from entering. If your gasket is torn or no longer sealing the door it will need to be replaced. This gasket is gray in color, made of rubber and measures 18” x 40”. To smooth the creases and folds in the new gasket, soak it in warm water and let it dry. You can also try carefully warming it with a hair dryer or heat on a low setting, but be careful not to melt the gasket. This is a genuine OEM part.

Door gasket - right side (refrigerator door gasket right side door)

Lamp cover (lightbulb lens cover, clear plastic.)

This lamp cover is also commonly referred to as a light lens. This is a genuine replacement part. It is used in a refrigerator to cover the light bulb. It is made of clear plastic. It measures 14 inches by 5 1/2 inches. This does not include the white plastic housing that the light is in, this is just the cover. To install your replacement part you simply snap it into place, no tools are required.

Evaporator fan motor

This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is suggested to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.

Door gasket - black (refrigerator door gasket)

This door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Door gasket - black (refrigerator door gasket)

This door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Case,lamp (light assembly housing cover. Located in top of refrigerator compartment.)

Basket assembly,door (door basket)

Light bulb (incandescent light)

Handle assembly,freezer (freezer door handle)

Handle assembly,refriger (refrigerator door handle)

Screws NOT included.

Guide,drawer (drawer guide)