LTM9000B LG Parts List

Micro switch (microwave door switch. This switch is normally open. When the microwave door is shut, the door switches close to send power to the microwave.)

The microwave primary door switch, also known as a micro switch, is normally open. When the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, then the switch has failed, and the part will need to be replaced. The micro switch is in the latch board section and monitors the position of the door. This part measures 1.5” L x .75” W NOTE: Due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge, even when unplugged. It is suggested to have a service technician install the part. This is a genuine OEM part. Please disconnect the power to the microwave before beginning the repair.

Locker (door latch hooks)

The locker, or door latch assembly fits to the inside of the microwave door, and keeps the door closed. If the door on your microwave oven doesn’t appear to close properly, you may have a problem with the door latch assembly. This locker is made of plastic and measures 7 inches long x 2 inches wide. If either of the hooks is broken or does not have any spring tension, you may need to replace the assembly.

Micro switch (switch,micro)

The interlock door switch, also known as a micro switch, will prevent the microwave from operating if the door is open. This switch has been updated by the manufacturer. It may appear different in appearance but will still function as the original part. This part has a green button and measures approximately a little over an inch long. This is a genuine OEM part. Please remember to disconnect the power to the microwave before starting the repair.

Switch,micro

This microwave micro switch is normally open and when the door is shut, the door switch will close to send power to the microwave to operate. If the microwave won’t start, then the switch has failed and will need to be replaced. The micro switch is in the latch board section and due to the high voltage capacitor in the microwave, it can retain a lethal electrical charge. Even when unplugged, it is suggested to have a service technician install the part. This is a genuine OEM part.

Screw,tapping

Motor, ac synchronous (turntable motor)

If the turntable on your microwave does not rotate, or you can hear a grinding noise, the problem may be with the motor. The motor is typically located below the floor of the oven, and is accessed through the bottom. The motor is normally held in place with a retaining screw and will have two wires attached to it as well. If the motor is making a grinding noise it will need to be replaced. If the motor does not turn, you can check for voltage or continuity with a multi-meter. Make sure the power is disconnected from your microwave before beginning this repair.

Diode (cable, assembly) (microwave diode assembly)

Shaft,turntable (turntable coupling)

Thermostat

Spring (spring latch mh-630h 640c)

Shaft,turntable (glass tray coupling)

Thermostat

Motor, ac synchronous

Motor, ac synchronous (turn table motor 120v/60hz)

Cable (cable,assembly)