YE20CA2 Magic Chef Dryer Parts List

M series new style coil kit (dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective.)

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Dryer radiant flame sensor (gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly.)

This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.

Door switch kit

This kit includes the switch and mounting clip.

Leveler (leveling leg)

This is an OEM part that is made of metal and sold individually. The leveling leg is generally used with refrigerators, dryers, freezers, ranges, cooktops, and microwaves. The leveling leg is meant to keep your appliance steady and level to the floor. If you notice your appliance is uneven to the floor it may need to have the leveling leg replaced. You will notice that the bottom of the leveling leg has a smooth surface to ensure moving your appliance does not require as much effort. This part screws into a pre-drilled hole underneath the appliance.

Ignitor (igniter, will replace round style only)

This igniter can only be used in place of round style igniters. This part ignites the gas within the dryer.

Connector (gas line. 4' stainless gas dryer connector, (1) 3/8" and (1) 1/2" fitting, (1) extra 3/4" fitting, pipe thread sealant, leak test solution, and instal)

Timer

Discontinued (drive motor kit with new start capacitor, pulley and hardware)

Cyl bearing (drum bearing assembly)

Door gaske (door gasket, gray rubber)

Lint scree (lint filter assembly)

Catch assembly

Door strike

Discontinued (no longer available)

Lp conv ki